| Tools Required:
Ratchet
10mm socket and wrench
Small and medium flat head screwdrivers
Medium Phillips head screwdriver
Small File |
Step 1: Remove the six clips on top of the bumper. Use a flat head screw driver and be very careful.
Tip: You may want to put a piece of tape around the end of the screw driver for extra protection from scratches. |
 |
| Step 2: Remove the six clips on the bottom of the bumper. There are 4 across the center and one on each side in front of each wheel. |
 |
| Step 3: Remove the four screws from the bottom of the bumper. There are two on each side in front of each wheel. |
 |
| Step 4: Remove the two screws that are located in the fenderwell. There is only one screw per side. It is located in middle to top of the fender. |
 |
| Step 5: Remove the bumper by pulling on sides first and then the middle. Set it on a clean cloth or towel to prevent scratching. |
 |
| Step 6: Take the drivers side brake duct (74152-S6M-Z00) and install a clip (91503-SZ3-003) through the hole in the rear brake duct mount onto the hole at the bottom of the washer fluid reservoir. |
 |
| Step 7: On the drivers side install the gold bolt (93405-0601608) through the front hole in the brake duct and frame. Attach it using a nut (no part number) on the back side. Tighten down using the 10mm socket and wrench. |
 |
| Step 8: Take the passenger side brake duct (74112-S6M-Z00) and install a clip (91503-SZ3-003) on the top hole and install the black bolt (90138-SM4-003) through the bottom hole. Tighten down the bottom bolt using the 10mm socket. |
 |
| Step 9: On the drivers side, cut out the a square the size of the brake duct using the template on the fenderwell (Honda included marks to help with cutting). |
 |
| Step 10: Follow step 9 on the passenger side. |
 |
| Step 11: Using an exacto knife cut out the stock grill. You want to start at the small slit and cut on the painted side of the bumper, it is a lot easier and it help you not cut the bumper itself. Be very careful if you try to go to fast the knife will slip and you will cut up the bumper, take your time with this step. Use a file to carefully clean up the bumper and smooth out any spots that prevent the grill and outer cover from fitting properly. |
 |
| Step 12: On the drivers side, mount the grill (71108-S6M-Z01) on the backside of the bumper using four of the screws (93913-141G0) provided. Start with hole that is just a circle and work your way around the grill. This will prevent any undo bumper flex and it will make sure the bumper will go back on properly. Take the other grill (71107-S6M-Z01) and install it on the passenger side following the same steps. |
 |
| Step 13: Mount the outer cover (71104-S6M-Z01) on the drivers side. Do the same on the passenger side (71109-S6M-Z01). They screw in on the back of the bumper using three screws on each side (93913-141G0). |
 |
| Step 14: Reinstall bumper reversing steps one through four. |
 |
| Miscellaneous Picture |
 |
| Miscellaneous Picture |
 |
| Miscellaneous Picture |
 |
Shopping Cart
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
)
