Shop by Model
Shop by Category

Shop by Car

Free Shipping!
Installation Instructions
Skunk2 Rear Control Arms Install
Tools Required:
  • Floor jack
  • Jack stands
  • 1/2" ratchet
  • 17mm socket

    • Have a question? Ask it in this thread on our message board: http://forums.clubrsx.com/showthread.php?t=631875
    What an purchase a set for yourself? Buy them now from Club RSX.com!
    Step 1: Jack up the rear of the car and put it on jack stands. Then put the jack under the rear control arm to support it. Using the 17mm socket remove the bolt on the chassis. Then using the supplied 10 point socket remove the bolts on the control arm.
    Step 2: Using the supplied steel mounting plate and 10-point bolts, install the bolts into the stock control arm but do no tighten them down yet.

    Step 3: Install the stock bolt back into the chassis and tighten it down to 43ft-lbs. You will find that you will have to move the wheel around to get it to line up. You can also use the bolt to help line it up as well, that is why it it has the end that it has on it.

    Now tighten down the three 10-point bolts to 95ft-lbs.
    Step 4: Repeat the steps for the opposite side.
    Customer Service Shop Club RSX My Account About Us Message Board Tech Info
    *Free Shipping applies to continental US orders only. Shipping to Alaska, Hawaii, International and items listed as truck freight are extra and not included in the free shipping offer.
    Errors in typographical content, pricing and photography are subject to correction and may change without notice.
    Some pictures used on this site are for description only and may not indicate the final product ordered.
    Copyright © 2001-2010, Club RSX, Inc. All rights reserved worldwide. Privacy Policy | Disclaimer Notice    		 Payment Options