Got brand new unused pairs of jordan playoff 13s, 275$ b.o shipped to ur door with tracking number sizes 8.5,9.5, 10 serious buyers only txt for more info and pixs 585 732 8154 will send pixs with username
I've been searching but I can't get the exact answer I'm looking for. This is my dd 05 type s and I'm not an all out racer but want to build enough power to hit my goal low 13s to high 12s is this possible without kpro or spray for what I'm looking to hit I'm praying its not necessary?
Looking for a daily driver and project car. I want to spend as low as possible and hopefully under $10,000. I want something that can get to low 13s at least. Any ideas?
What I was thinking about:
Camaro Z28 LT1
any other ideas? Suggestions?
i just got 2 new mods that i just installed... an injen cai and the new megan racing exchaust..will this bring down my times to 13's..
this are my time w/ out the 2 new mods:
1st/ 2nd/ 3rd
r/t.....443/ .121/ .325
60'...2.329/ 2.415/ 2.193
330...6.310/ 6.282/ 6.044
1/8...9.536/ 9.417/ 9.205...
Went back to Sacramento Raceway last night. They have $15 racing Wednesday night and you can get as many as ten runs in if you're lucky. Sacramento is a hot place in the summer, so temperatures usually hover around 100 and the track can be way hotter than that. Also, it's a small, low-budget...
I finally got back to the track after I got my problem sorted out.
This is my running down the strip with my setup, so I am still getting use to it.
Got 4 runs in:
14.35 @ 101.29 mph (had a nice 60' but I could find 2nd gear for some reason)
What could get a DC5R into 13s on street tires N/A?
(DC5R+Toda N2 kit & RH + Rnd ported K20 type r head +iceman intake+ 2.5 ich catback exhaust + ATS 5.026 Final Drive)
Would this be a good N/a set up that would be able to get me a 13.6-13.1 (on street tires) in the 1/4 mile and what would be...
I have an stock 02 type s.How can i get low 13s. I am on a decent budget, and am willing to go forced induction. I just need it to still be a daily driver. I was thinking of building the motor, and then a shot of zex. any opinions? btw, this is my first time on the board, and its great. thanks...
Well I can't get much closer and still miss 13s. 14.018 @100.8 mph. 60' was 2.264. I just can't seem to get any traction. Most of my 60' times were in the 2.31-2.35 range. I spin so bad shifting from 1st to 2nd that my front end slides a little sideways during the shift. I know tires is...
Went to the track the second time around with my new tires and still can't hit 13s :firemad: . My 60' is owning me and after 7 runs, I am still not used to em...finally got the gist of it last night on my last run. Gotta practically drop the clutch, go figure :dontknow: .
Anyways, my best...
alright i want to know what other mods besides intake header hondata tires es mm would be needed to get a mid 13 like 13.6 or better i mean most people get 13.8 with intake tires and hondata 4. what other best bang for the buck mods would u need to run a 13.6.
got to the track for the first time this summer (cecil county, MD). first run, ran a 14.01 @ 100.5 with a 2.23 60' (25 psi and full interior), but than it started raining :( .
It was 65 degrees, 65 % humidity, and my first time running with the toyos, mm's and race header (and the first time...
finally hit it at 13.912!!! the rest of the runs were one 14.0, some 14.1s and 14.2s. The track was extremely hot, I had my tire pressure at 24psi. Ran the car with full interior and a sub. Now I can retire the stock tires and get some Azenis to hit some mid 13s :D
EDITED: I don't know why...
Id like to stay N/A as long as possible. So i am swapping in the Type R. Dont tell me its not worth it. Iv read through this all and decided I liked it. What else Do I need to do to it to get into the low 13's? About how much HP am i gunna need to have the abilty to run that. I do have...
I've been on this forum for a while now and i still dont know which part to choose to reach my goal which is to hit high to mid 13s with a type s. I have a setup in mind but I want your suggestions first.
Just for you to know, I will begin with a good set of wheels and tires...
I was just watching some show on TNN which I've never seen and they talked to a guy with long hair and a hat who said he was the first to get an RSX-S into the 13s all motor. Just curious if it was the guy who did it from this board... JDKindle was it? Sorry if I've got the name wrong I'm not...