Hey guys, I'm selling my rsx-s to fund other project cars. It has 214,000 miles, but it drives great. It holds a clean title, but the hood is damaged and the front bumper, driver side fender, and driver side headlight have been replaced. Interior is in good condition except that the...
Rebuilt 2006 Acura RSX JGM base, manual transmission, with black leather interior. Car is in very good shape and was purchased from a dealer that specializes in rebuilt cars in 2012. I have all service and repair paperwork from when I purchased the car. Shift boot has tear and small tear in rear...
I am not sure why my previous post cannot be seen. Please feel free to delete the other one since it doesn't appear to be showing anymore.
But since then, I have updated the information to be more accurate and have also included pictures. I just posted it on Craigslist, so please...
Listing is for:
2002 White Acura RSX Base for $3000 OBO
- 270,xxx miles on the vehicle
- first owner - female (used for commuting)
- never modified, stock
- not salvaged, clean title
- automatic transmission
- leather seats (driver seat is torn from normal wear and tear)
Selling my 03 Nhb Type S
Title: Salvage by theft recovery
Location: Orange County
Car runs perfectly fine. I bought it in 2007 as a salvaged vehicle. The owner of the car told me it has that title because the cars front end was stolen however...
NOPI NATIONALS is returning Sept 22-23, 2012. We hope this is welcome news and that you and/or your club or group will make plans to attend.
It’s at a new venue: Atlanta Dragway. It’s a world class Drag Racing facility located is about 60 miles northeast of Atlanta. There is a link on the...
Selling the very first car that I owned...been driving it since high school
right now I am using it as a shop car to carry wheels/tires
recently bought an 06 Mazda5 for an upgrade...time to let it go
Model: Mazda MPV LX Minivan
Color: Shimmering Sand exterior / Beige interior
Location: Stanton, CA
Killer deal! $2500!!!
Block Only $1500
8k miles on motor, perfectly good! We can install on location if needed :thumbsup:
K24A4 Block 87.5mm
Blueprint pro-lite I-beam Rods
K20z1 Head - cleaned - valve job
Blueprint Stage 3 cams...
After 2 blown k20 motors (:fuu:) I decided to start all over with a K24 frank build. Finally got it tuned and made some good power....:jelly:
***Special Thanks to CRSX, Doug & Robby for the help and to Daniel for the great tune***
K24 Block 87.5mm
12.5:1 Weisco / flat valves