Search Results for ‘adjust’

im having trouble adjustjng my cmc pushrod, i spin it all the way clockwise and counterclockwise i still have too much resistant on my pedal, and if i try to push hard on it my cmc seal on that triangular piece would break making a loud air pop noise and would start leaking fluid... What do i...

I took my 2002 Rsx Type-S in for an alignment and when It was finished they gave me a paper stating *Adjustable strut mount required to adjust caster angle*. Could that be the reason why the ride is so bumpy?:rest If so, could you send me a link for adjustable strut mounts for a dc5?

A few months ago my 2004 RSX Type S had a low idle issue. Check engine light was on, with a code p0506 --- low idle speed. It frequently stalled at red lights. I replaced the IACV with a new after market one. The stalling problem was gone. However, the check engine light was still on, with a...

Ok I have a question I wanna see if anyone knows how to adjust the rear camber kit on the dc5?if anyone can help me thanks

So I have an RSX and it idles fine (around 700rpms) however the poor thing was in a crash and the front motor mount is toast and basically un-replaceable and the problem is at low idle (less than 1000rpms) the car shakes horribly. Is there any way to manually adjust the idle to sit at 1000 or...

I need the tools to adjust the Megan Coil-Overs that came on my 05 Type-S. Anyone got any they want to get rid of?

new to the k20 world and still learning. so I just picked up this rsx type s to find it had more then just the o2 sensors bad like everyone claims. so I check the cels and find its both 02 sensors knock sensor and tps. I go to the parts store order a knocks sensor ect.... install all the parts...

Hello, I have an intermittent p0171 too lean code. I have run diagnostics on it all seems good I also have a slight hesitation I have read that this could be valve clearance, fuel injectors, or fuel pressure regulator The problem i am sure is related to the weird hesitation i have it...

How do you calibrate the tps using a voltmeter? I have a voltmeter but no idea where to put the red and black cords.

My ride is super bouncy, it's like I'm riding around just on springs... Increasing the dampening seems to just increase the stiffness, but the bounciness remains! At this point I'm thinking that I put too much preload on my springs when I installed them. The springs that come with the coils...

my hood isn't closing properly. i have some play on the front and along the driver side, it seems lifted. i'm thinking might be the latch release that pops the hood up. i heard i can adjust it but don't know. i want to see if this helps the alignment. also anyone have the part number of the...

Did my valve adjustment twice set then in the middle at 23 and 27 made noise now set then to 21 and 25 still noisy a little less so now they are at the minimum spec what should I do to get rid of this it's cause a knock low end driving its a k20Z1 motor

Want to lower my car a little bit more, is there a way i can adjust the height without taking them off? and how would i do it?

How to?

I installed TheRetroFitSource HID's and upon completion I noticed my passenger side light was aimed way up so I adjusted it to match the drivers side, but now both lights are really far to the right side of the road, so my question is, how can I adjust the lights from side to side or left to...

If you lower the engagement point, will this create more slack at the top of the pedal? or will it still be just as firm throughout the pedal stroke but just engage quicker?

Hi i will go tomorrow to a shop to align the car . I am from austria and i dont know if they have the specs for a Rsx . can someone tell me the specs. for a 2004 Rsx i need the specs for chamber adjustment and align ! i hope i will get some help

...

It's a pretty out there question. I just don't want to have to jack the car up every time I want to adjust them.