Acura RSX, ILX and Honda EP3 Forum banner

bolt

  1. Battery Tie Down Bolt

    Problems & Solutions RSX
    My battery tiedown bolt got swallowed by my engine bay and I can't find it, I checked the search but the only results were talking about the other bolt. Where could I find the battery tiedown bolt closest to the headlights? Or what are the bolt's measurements? Much appreciated :)
  2. 17mm Bolt size question

    Transmission & Drive Train RSX
    Hello, I just replaced my clutch/flywheel. There was a 17mm bolt that I believe went through the starter motor that I stripped pretty bad. I was able to remove the bolt, but I want to replace it with a new one. I have searched through many part lists, I am having trouble locating this bolt. I...
  3. Front seat bolt size

    Interior Mods RSX
    Im in need of help. Anyone known the thread pitch for the poem bolts that hold down the seat to the car frame thanks in advance
  4. need help identifying bolt

    Problems & Solutions RSX
    I recently did a clutch replacement and ended up with a left over bolt. For the life of me I cant figure out where it goes. Any help would be appreciated. There's red paint on the face of the bolt. 14 mm head 9 mm diameter 40 mm bolt length 49 mm over length
  5. Identification of bolt on Parts

    Bolt-On Basics: RSX Type-S
    Hi, I have these two bars (see photos) that were given to me along with some other accessories for 2003 Type-S. I have no idea what they are and where they would be installed. Can anyone help me ID what they may be for. They are definitely for the RSX. Thanks!
  6. Will Spoon N1 axle back bolt on to Mugen b-pipe?

    Bolt-On Basics: RSX Type-S
    Will Spoon N1 axle back bolt on to a Mugen twin-loop b-pipe without modification? I like the clean sound of the mugen for daily driving but would prefer something a little louder for the track. If it’s a simple bolt and switch, i’d br ideal for my situation.. anyone have experience w/this?
  7. JNC001 CCW replica's have 2 bolt patterns on wheel, lol

    Wheels & Tires
    Well, I was seriously considering purchasing a set of JNC001 CCW rep's from aspire motoring, only to find out the wheels have 2 bolt patters (5x100 and 5x114.3). To me, that just doesn't look appealing to me. I found another company in northern cali that used to make them, but not the size and...
  8. Cusco Bolt In Cage

    Interior Mods RSX
    So I've been researching buying a 6 point dash avoidance Cusco bolt in roll cage. I know a lot of guys went with the Autopower, but is there anyone running the Cusco 4 or 6 point with a full interior? I keep getting mixed answers on how hard it is to fit with the carpet and headliner in...
  9. Strut bracket moving with bolt

    The DIY Garage RSX
    This is my first post. Ive found lots of useful information on these forums to help me fix this car. I bought a 02 RSX at a auction with the intention of selling it but I actually like it so much that my new plan is to keep it for awhile then sell it and buy an 06. Anyways. I started removing...
  10. Mtec shifter springs stuck bolt.

    Bolt-On Basics: RSX Type-S
    Just bought an 06 type s and thought I’d start throwing some mods at it. Someone suggested shifter springs and i thought for $40 why not. Well i can’t get that 8mm Allen bolt out to save my life. Anyone have this problem before? Any suggestions?
  11. Need Help ASAP PLEASE!!! Stripped auto tensioner bolt head.

    The DIY Garage RSX
    I recently purchased a 03 Type-s and about 2mths later the alternator went out. Long story short I got the belt off (not completely) and was able to swap the alt’s. Putting the belt back on my 14mm wrench is just turning on the bolts head. I will get this replaced but right now I just need to...
  12. 6MM Hex Timing Chain Guide Bolt Stripped.. What should I do?

    Problems & Solutions RSX
    While tearing down this monstrosity of a mess that is this K20A2 I bought, I have a few issues with some bolts. The Hex bolt in the head that holds the rear guide is stripped. My first initial thought was stuffing the biggest extractor into the 6mm hole and giving it hell, but im afraid that due...
  13. Dc5r AP racing front brake kit directly bolt onto rsx?

    Suspension, Chassis & Brakes
    Hi all, basically I want to upgrade the braking on my 05 rsx-s. However the AP brake kit was built for DC5R. The shop doesn't have any info on rsx-s, but their kit does fit dc5r and UK dc5 non type r. Can anyone help out to clarify abit? And what addition dc5r parts I need to get in order...
  14. Is there any way to mount a rim with a 110x5 bolt pattern?

    Wheels & Tires
    Hi everyone, So long story short, when buying my aftermarket rims, I ended up with three good ones but one that has the wrong bolt pattern. I have the Buddy Club P1s, 17x7.5, in Gunmetal. I love these rims and have searched extensively but can't find a place that will just sell me a single...
  15. I stripped the rear camber hole (where the bolt goes in) what can i do?

    Problems & Solutions RSX
    Hi! Long short story I begin working on my RSX late last summer. I decided to keep the old thing and redo a entire brake and suspension swap with new parts. The only thing I didn’t replaced were my ingall rear cambers..... Soon to regret after installing everything I ran into a problem with...
  16. Just got my 03 rsx base what are some bolt ons i could do ?

    Bolt-On Basics: RSX (Base)
    Just got my rsx it’s a base but want to know what I can do to make it more fun to drive Sent from my iPhone using Tapatalk
  17. Stuck and rounded out timing chain guide pivot bolt

    Problems & Solutions RSX
    Hey everyone. So I'm in the middle of doing a timing chain job for my Type S. Was all going decent until I couldn't get the hex head bolt out for the left timing chain guide. Allen key felt loose at first but would still hold. Bolt would not come loose with any amount of pressure. Ended up...
  18. Basic Base Bolt Ons Power Gains..

    Bolt-On Basics: RSX (Base)
    Hey guys I'm new here, recently came into a 02 base model 5 speed RSX. I traded up from my terribly slow NA is300 so for the time being the 5 speed is pretty peppy in comparison. I have a greddy turbo kit, but I'm not sure of the reliability of a boosted base RSX, that's not really a popular...
  19. k20/k24 Frank Bolt On Questions

    Bolt-On Basics: RSX Type-S
    Hello all, this is something that I have asked my friends about, but they seem to not give me a clear answer. Disclaimer: I have the 05 Base auto RSX. In the future, I want to do the k20/k24 frank build, so what type of bolt ons should I be looking for? Do I look for bolt ons that fit the Type...
  20. Bolt pattern

    Forum Threads
    I have a question I hope someone with prior experience or knowledge can help me with. Did the bolt pattern on the type S engine for bolting the transmission change from year to year? I have a 04 transmission trying to bolt it to a different year motor and one of the holes on top side of the...
Top