Search Results for ‘codes’

I bought a 04 base model and have been slowly getting her back on the road. Well today the smog tech told me she will fail if he runs the system due to the cat censor not being ready.. he told me to look up the drive cycle, do it and come back.. so I did and still same result.. he told me...

Impact Tools, Tuning Software, Headlight Repair Kits, and Other Huge Black Friday Deals and Promo Codes It's been another busy day as we roll towards Black Friday, the deals keep rolling in. Here's what we've tracked down for you so far today. 3M Headlight Restoration Kits on Sale...

Impact Tools, Tuning Software, Headlight Repair Kits, and Other Huge Black Friday Deals and Promo Codes It's been another busy day as we roll towards Black Friday, the deals keep rolling in. Here's what we've tracked down for you so far today. 3M Headlight Restoration Kits on Sale...

Impact Tools, Tuning Software, Headlight Repair Kits, and Other Huge Black Friday Deals and Promo Codes It's been another busy day as we roll towards Black Friday, the deals keep rolling in. Here's what we've tracked down for you so far today. 3M Headlight Restoration Kits on Sale...

How do I Disabled the Factory Car Alarm so I can Start my RSX?

Hello everyone on club rsx looking for someone to correctly identify this tranny as a 6 speed. I’ve been to the hybrid racing forum where most of the codes are listed, still nothing matching this code. Was told it’s a 06 -s, can’t be sure. Thanks in advance.

First off the car has K-pro, Skunk2 alpha headers, and a k&n typhoon SRI. If that matters. I bought it like this. I tried cleaning the throttle body and the 02 sensor looked decent. It only has 1 primary hooked up, no cat, and the evap system doesn't seem to be hooked up either. It smells like...

I have a 03 base, when I picked up the car it had a knock sensor code and an oil leak, Saturday 2 September I tried decreasing the engine to find where the leak was coming from and when I went around the block she went into limp mode. When I got home and pulled the codes they were p0325, p1259...

My 2003 RSX type S was scanned to read the engine codes and shows: P1457 EVAP System Leak detected(Canister Area) P1298 Electrical Load Detector Circuit Input High p1457 EVAP System Leak Detected (Canister Area) Says the most likely solution is to replace the EVAP by-pass solenoid valve. Is...

I am looking to join the RSX club but I need some advice! I checked out a 2002 RSX [Regular, 177K miles]. While it did not display any CEL codes, I scanned the car and it had the following codes: P0661 - IMT (IMRC) Circuit Voltage Low P1298 - ELD Voltage High Here is my problem - I live in...

So i have had my 2002 RSX Type S for around 6-9 years now, completely stock, haven't done anything to it besides routine maintenance. Entire time i have owned the car i ocassicnally get the check engine light coming on and off. Bought a reader years ago to diagnose the issue and found it was...

Had a "friend of a friend" replace clutch on my 2002 RSX type S. During replacement, I was I formed that he accidentally broke the Knock Sensor while putting Starter back in. He assured me he ordered & replaced a new one. Car was delivered with no mention of the check engine light was on...

Srs codes are 9-2 9-6 1-4 Where should I start? Could the air bad module be bad? The srs unit? Or is there something easier I could do to check?

Long story short I took my seats out to clean the interior and forgot to disconnect the battery first like and idiot. Now the SRS light will not go off even after trying the SRS reset procedure. I keep getting codes 15-1, 12-1, 22-1. 15-1 :: Faulty OPDS unit or OPDS unit not initialized 22-1 ...

My car has been throwing a lot of engine codes lately and the "check fuel cap" warning comes on too (usually causing the code to be thrown). I've checked the fuel cap each time and it is on securely (retightened to make sure), with no air escaping when opening it and always tightening 3-4...

This weekend I finally decided to install my Kpro 4 ECU (ECU is a PND that was sourced at the time, and Kpro installed) into my EP3. I removed the ground terminal on the battery, then proceeded to remove my PRD ECU. I installed the Kpro'd PND ECU and re connected the battery. Pulled out a...

Hi im the proud new owner of a 2002 rsx base model. I love this thing already!!! :fistbump: I have a few small problems that im trying to get straight to make this my reliable daily driver. I have been chasing cel codes and now im just lost, looking for some input or thoughts... car has cai...

Whats up CRSX. Ive been lurking for a while and buying parts but never really posted. I have a NHBP 02 Type S with 120k on it. Currently running a hondata reflash, Injen CAI, with a Borla catback exhaust. Everything else is completely stock engine wise. As many other rsx owners I got the...

Hey Guys, I'm looking into resetting my EPS BCU.. I installed the EP3 EPS System 3 years ago in my DC5 with no issues and just recently when I removed the rack and pinion to change up my inner tie rods everything stopped working. I have check voltage going to the BCU which checks good and...