Acura RSX, ILX and Honda EP3 Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 87 Results
  1. Problems & Solutions RSX
    So unfortunately over the weekend my wireharness somehow got caught in my serpentine belt and ripped the connector to my crank shaft sensor. I’m being told by Honda there is no replacement plug and a entire harness kit has to be replaced... I can’t be the only one who has ever had this issue, or...
  2. Turbo RSX
    Hey guys quick question, It might be a dumb one, but I was wondering if it would be beneficial for long term performance if I were to upgrade my stock K20A2 crankshaft with 200,000 miles on it, for a steel 4340 stronger crankshaft. Like the title says, for turbo of course. Possibly around...
  3. Turbo RSX
    Hey I have a quick question, Building a turbo K20a3 obviously. Would I be better off balancing the beefy ass rods, pistons, and wrist pins to my stock a3 crankshaft ( since I know it's not balanced from the factory ) or just getting a good used a2 crank and rods, pistons, and pins instead? I...
  4. Want To Buy or Trade RSX
    WTB K20 Crankshaft and valves. Let me know
  5. Problems & Solutions RSX
    I have been hearing this noise since past few days and it is from crankshaft pulley, belt tension is fine, I’m using gatorback belt. Noise goes away for a few seconds when i spray WD40 or water on pulley. Any idea?
  6. All Motor RSX
    As the title states, will these fit STD sized bearings and oem crank? Like can I just swap them right in place of the oem rods? All help is greatly appreciated...
  7. Want To Buy or Trade RSX
    Wtb k20a2 crankshaft. My 2002 acura RSX spun a rod bearing and warped the crank. Please let me know if you got one for sale.
  8. Problems & Solutions RSX
    I have a 06 Acura rsx type s i am looking for the part number for the crankshaft pulley. can someone please help me? Also any suggested sites will be helpful
  9. Engine & Transmission RSX
    I have for sale a great condition k24a2 crankshaft. This crankshaft is the best balanced k24 crankshaft. I bought it with plans to build a high reving NA k24 setup however that is not happening anymore. This crankshaft is also swapped in s2000 motors for stroker setups. K24a2 Crankshaft -...
  10. Want To Buy or Trade RSX
    I need a crankshaft pulley/harmonic dampener for a 05/06 type s rsx. Pulley must be from the k20z1 engine.
  11. Want To Buy or Trade RSX
    I have a 2006 rsx type s and I need a new crank, I made the mistake of getting a k20a3 crank thinking it would fit so now I'm out that money and can't find a z1 crankshaft!! Needs to be shipped unless local (Kansas) thank you! 316.619.6631 txt please
  12. Problems & Solutions EP3
    replaced the crankshaft seal & valve cover gasket. now the car starts up for about 2-3 seconds and shut down. -not fuel pump or fuel filter. checked both. getting pressure. -checked main relay. -checked grounding. -checked ignition coils -replaced crankshaft sensor with a new one.
  13. Engine & Transmission RSX
    Selling a K20A2 crankshaft. Would be good as a core unit for someone that would like to knife edge and polish it. $275 includes shipping, packaging, and Paypal fees of 3.5%. Slight knick on the counterweight below cyl 1. Selling a set of K20A2 OEM camshafts. $175 includes shipping...
  14. Engine Building & Design
    Are all the k24 crankshafts interchangeable? Or do certain ones only work in certain blocks. I'm looking at putting a k24z3 crank in a k2a4 block. I would assume so but sometimes its not the case in certain series engines. Any positive info is appreciated. Thanks.
  15. Part Outs RSX
    K24a2 bareblock, crankshaft, piston, rod for sale, all in good condition no crack or scrarch on cylinder walls, ,new to selling item here i cant figure out how to upload pic, but if u want to see pic of item i have it listed on ebay. Asking $260 crank, $280 bareblock with oil squirt. piston...
  16. Problems & Solutions RSX
    i was wondering if when replacing the crankshaft position sensor on a 02 rsx will any oil spill out? or would i need to drain the oil then replace the sensor? reason i ask is cause the sensor is next to the crank pulley and it makes sense oil would start shooting out of the hole when i get the...
  17. Want To Buy or Trade RSX
    W.T.B. K20Z1 usable crankshaft. P.M. me price and mileage please.
  18. Want To Buy or Trade RSX
    In need of a 2002 - 2006 Type S Crankshaft. Paypall Ready.
  19. Want To Buy or Trade RSX
    Just like the the title says, I'm looking to buy a K20Z1 crankshaft. Thanks
  20. Want To Buy or Trade RSX
    Looking for a K24 crankshaft (in good condition..ready to drop in etc.) i would like a tsx one pref. But others would be fine..lmk In orange county,ca
1-20 of 87 Results