How's everyone doing, previous owner of my 03 type s cut the wires for the rear speakers and the stock bose sub. I was wondering if anyone knows where to get replacements? Tired of listening to my HU through the front speakers lol.
So last night I swapped out the stock header to a skunk2 alpha header with a brand new o2 sensor and it went good, but this morning I’ll be driving and if I’m low in the rpms and push on the gas the engine just cuts. It doesn’t fully die but will act like i’m not pushing the gas till I left off...
Cut RBC with the following included...
OEM RBC intake manifold cover w/ hardware
Hybrid Racing RBC Adapter
Hybrid Racing RBC Thermal Gasket
Hondata Intake Manifld Gasket
$300, Text for a faster response 215-801-3654
Kinda dumb but will the no cut k swap k tuned shifter bolt right into my 06 type s ? What about the kswap 304 421 header ?? Will they fit in the RSX at all ? Found a really good deal for them.
Sent from my Nexus 6P using Tapatalk
I am looking for a front clip from a Civic EP3. I need the following parts
- Radiator Panel,
- T frame
- Front fenders,
No lights, bumper or dash necessary.
If I can get the shell and body parts together how it is on the below photo (no engine...
Can you Get a Key Cut Without the original key?
I have a 2002 RSX.
When I bought the car I was given 2 keys.
I live in Canada and use to use the second key to lock my car while running it to warm up the car in the freezing winter. Years ago i lost this second key and was not able...
I just picked up an 06 Type S and I noticed that whenever I would move the passenger seat the right speakers would cut out until I shifted my seat around again until they came back on. Yesterday the seat got moved and then all of my speakers cut out and won't come back even if I...
Recently I've been hitting fuel cut at about 7k and doesn't go past that much, I'm not sure if its because of the cold weather that makes it run too lean or if I need a re tune on my kpro? Or bigger injectors and fuel rail?
hey guys, I am very inexperienced working on cars. really just starting, only installed my k sport coils and CAI. After I did coils I took my car to a shop to get new tie rod ends and rack and pinion installed. Now I took my car for alignment and the guy working said because of how low I am...
I've spent days looking around the forums and couldn't find any advice on where you I should make the cuts to fit the fogs on the Mugen 02 rep lip. I've already made some cuts *shown in picture* but the hole to screw in the fog is a little less than an inch from lining up. I've tried pushing the...