Search Results for ‘easy’

Depo Lights. Had the same ones previously. But they were hooked up w/ HIDs and the plug labeled in the picture was just dangling. But since I don’t have HIDs anymore where do I plug it up at? Turn signals and high beams work, but headlights won’t come on...

Last night I installed red fabric to my door panels using adhesive spray and tucking. End result looked pretty good except where I pressed on the fabric to hard to bond the adhesive. Some spots formed from seeping through the fabric. Does anyone know any home remedies for removing dried 3M...

If you can't find a box for your wheels or are just not sure how to ship them? Here's an easy way to do it through the post office and it won't cost you much... First, you will need to go to a office supply store, like Staples. For a set of fours wheels you will need to purchase about 80 yards...

Hi guys, I have a 03 Acura RSX base model and I am trying to figure out how to properly change my transmission fluid filter. Any advice will help and pictures are very helpful. Also what would be the best transmission fluid to change it out to? Thanks in advance!

Searched a little but couldnt find the size of the Type S rotor screws (that hold it in place). Drilled em out and wanna replace em.

Let me start off by saying this probably isn't the safest way of doing things, but this is the way I did it because I found it pretty simple. Disconnect your battery when working with electrical wiring. Check your fuses when your done if you have any problems. 1. Take the pigtails from the LED...

so,,been searching around, seems like lots of you are having this problem but no one have written a solution, hope this helps first of all i didn't do this, some random guy at the tire shop jacked my rad support and it bent:bsflag: hood won't close properly tools you will need : jack jack...

so you got your red h and then you go to put it on and then you say.... ''how the frank can i do this? i cant see anything!'' first, cut it as close to the border as you can, leaving a little tab to pull the top off now you have the most room to be able to place it on perfectly! so go ahead...

This has been covered and I have searched like crazy, but I still have a few unanswered questions. From the information I have gathered it seems like all you need is the calipers with brackets and hardware and the pads and rotors. That sounds great, but bc of the larger rotor size wouldnt the...

I need to barrow a 05 type S cat converter. I will give you 100 and full DC headers to barrow it i can take it off myself or have a shop do it. I will give 500 to hold on to until I give you back the converter that same day. Thanks

Is there a difference between the stock 05 Type S shocks and the A Spec shocks? Talking shocks only....not springs.

Hello all, There's nothing fancy or "new" about this DIY, but I just thought I's share my experience with this project, as I think it came out really well. I had considered the DIY felt carpet project, but then began brainstorming of ways of an even higher-quality alternative that...

I was pretty bored today and my headlights were hazing. I found a bottle of Meguiars Scratch X 2.0 and thought to myself, hmmm it is a micro abrasive so lets try it out. I applied the Scatch X by hand using the buffing pad that came with my Meguiars NXT wax. I applied and buffed in a circular...