I'll try to keep this as short as possible. I have had my 06 rsx (bought used) for over a year now, it had a 6 speed installed by the previous owner which had problems with third gear. Couple weeks ago I finally decided to go ahead and put the stock 5 speed transmission back in.. It went perfect...

So I’ve been told by a couple of friends and by my tuner that I can use my stock ecu( my 03 type s ecu) on a k24 as long as I have kpro installed is this true somebody pls let me know.

I read on a forum somewhere that the stock ECU can adjust for about a 20% larger fuel injector and still perform optimally. Is this true? Are there any injectors you can put on to get gain without a reflash?

So I am doing a broke boy swap in my rsx a k24a4 with a rsx base model 5 speed transmission. I want to start of by saying I have purchased k pro but the back orders are 4 to 5 weeks out and this is my daily so I kinda need it now. I've heard the crv ecu has the same pinnout as a rsx but ill need...

Why does no one run anything besides Hondata and Ktuner (sometimes Haltech)? I'm currently in process of building a boosted K20Z1 in my 06 Acura RSX Type-S and I was just wondering why no one else in the community steps outside of these two ECUs. With the limited capabilities and STILL not...

Hey everyone. I've gotten a little desperate searching for help, all of the Facebook groups are useless with advice on my issue and I was hoping somebody could point me in the right direction. Here's my situation: I have a RHD-converted RSX with an entirely original engine harness. I drove it...

if you have any good core ecu let me know

Comes with adapter Asking 1,000$ obo

Need it shipped to 90631 unless close by ready for pick up thanks!?

hi? i have a 2004 acura type s six speed. i need to change my engine ecu. my ecu is not communicating to my OB2 and my car doesn't start but it cranks and all dash light turns on . no blown fuse is there any problem using an ecu from a 2002 to 2004 on my car. do i need to match the...

hi? my ob2 port was working just fine. i got the code PO122 from it with my tester. trying to checking the resistant or volt on my tps wire. i unplug the plug from the tps sensor. i used a voltmeter. as i set up to test the wires, i plug the voltmeter black wire to battery ground...

Do you guys know if an Ecu tune / Calibration from a shop who dyno tune my car can make my head gasket blow? Or its just wear and tear? Im asking because a friend of mine used my tune and we went to track then he said that my tune blows his head gasket?

So I booked an "appointment" to have my car tuned as the guy was doing a discount until the end of the month. He's explained it to me but it all seems fishy because we aren't meeting in an actual store but at a McDonalds. It's not even a reflash or a new ECU but he said it's a chip that plugs...

This ecu is PRB and is V4 kpro please do your research first before you call me crazy or give me an offer.

Anyone know where I can get ktuner ecu for 2005 Japanese dc5 type s (k20a3) Think it’s 3 lobe cams

Does the NZDM DC5 automatic Type S (05-06) use the same ECU as the American RSX type S (which only comes in manual), or the same ECU as the American base model RSX (which comes in manual and auto). I also don’t know if the New Zealand type s is a k20a2 or k20a3

I have an 05-06 ECU with the Hondata RH reflash. Hondata no longer offers the RH reflash due to emission system disabling included on the “tune”. I have the ECUs serial number if you wish to contact Hondata and verify the tune. I have the immobilizer to throw in with the ECU as well as the...

Anyone running this setup? I've heard it runs lean and throws codes; I'm assuming its due to a difference in fuel maps and cam phasing? If you guys have this setup, are you running lean and how are you compensating for it? Before you guys bust out the flame throwers; to legalize a k24...

Looking for a stock type s ecu. Thanks!

Hello guys, I was wondering if I purchased someone's stock ECU would I be able to install into my car without needing anything else?