Hi everyone is time for me to change the filter of my cai but I was thinking why not upgrade it and get maybe a bigger size with a velocity stack, like 3.5 and velocity stack with a reduced for fit it on the CAI?im thinking about this just for try to squeeze a little more from my cai, or it...
Today my car decided to go up in smoke. I pulled into a parking lot and found that my oil filter completely exploded off of the engine block. There is not enough thread left to hold the filter on. Eventually I will most likely have to replace the bottom end, I just have nowhere to do so until...
Cleaning out my basement and found some parts that could be of interest:
1) OEM Headlights 06 RSX-S with Lexus RX330 retrofitted projectors and custom shrouds. Headlight lens was damaged from an accident but the retrofit components (Projectors & Shrouds) are mint, perfect donor parts for a...
My previous oil change, I did it at the dealer and now I want to change the oil my self.
I got an oil filter wrench that fits the new Honda oil filter (15400-PLM-A01) I want to put in, but the wrench is too big for the oil filter installed now. What acura/honda filter did the dealer put in...
How often do you guys change your engine air filter?
My RSX is not tuned, just a daily driver. I just changed it about 2 years ago and am thinking it is time for another change.
I understand some may say follow the manual, but I was thinking of maybe doing it more often to keep dust...
Exedy Master cylinder never used: $30 shipped
Exedy Slave cylinder never used: $30 shipped
Honda tie rod ends never used: $60 shipped
Stock air intake filter never used: cost of shipping + $5
Thanks for looking
PM, text, or reply below 8645979908
I just bought used AEM V2 Intake set in decent condition, but I have a doubt should I install used filter from the set, or buy new one. In the used one the outer rubber layer is going off (layer under looks ok).
What do you think?
Pics below (click to enlarge):
This probably the wrong sub forum to post this. But I'm using my phone to type this and I'm at work. Most of the posts I've seen say an s2k oil filter will work on a type S. But will it work on a base?
Just bought a used 2006 RSX and I am really enjoying it. It's got 113k miles on it and I know I need to do some maintenance. One of them is tranny fluid which I already swapped out and plan on doing it again very soon (to get the remainder of what was in the torque converter out), but I...
Tried searching many forums but couldn't really find anything on mobile. Looking to buy a k&n crankcase breather filter and need exact sizing. I believe the valve cover hole size is 5/8 in and need a filter with a nipple of 1.00 in diameter correct ? SIDE NOTE: I accidentally ordered a 2 in...
Used Armrest in Ebony Black Asking $80
Used 05-06 Type S Axles - Asking $100 Passenger Side CV Boot Ripped. $15ish for a new one
New AEM 21-204DK 3.5" Inlet x 5" Element Dryflow Air Filter
I Believe its for the AEM V2 Filter, little damaged from shipping - Asking $35
I have recently took the risk to try and change my fuel filter on my dc5 by myself to try and learn to do more things on my own. However I messed up and accidentally ripped a thin copper piece which was connected to a black wire and the fuel filter black clip. I tried to electrical...