( new to wheel specs ) Just picked up some clean white type r wheels for my 03 base. I know I will need spacers but not sure if 10,15,20, or 25mm will will work best, I don’t mind them being flush to the fender,I just want to mount them already lmao. advice on what brand/size to get or that will...
Installed new hood but find the rear corners are sitting about 1/2"-5/8" below the top of the fenders. See photos attached. The front seems to line up ok at the lights and grill.
The old hood sat the same way. I thought maybe the corners were bent but new hood is the same. Is there a spacer or...
Hi, just got a 2004 RSX S with 72k miles and wanted to know if xxr 527 18x8.75 +20 with 215/40 tires will fit without rubbing, I have a spec suspension but I could get coilovers. I have a good deal on these rims but don't know if they will fit. Thank you
I bought some headlights recently and didn’t realize they only fit stock bulbs. Anyone know of a way I can modify the housing to fit LED’s or would HID’s fit? Any threads where someone has done it before? I didn’t have any luck in my search.
Sent from my iPhone using Tapatalk
Working on the Fuel System and got the 21U-01-0800-4 Deastchwerks injectors (800cc). I removed the old rail and injectors but I'm having issues getting the new ones to fit into the Intake manifold. (they seem to fit into the fuel rail fine) Anyone else have similar issues? Figured...
I’ve lowered my RSX by about 2 inches from stock on coilovers. I’m planning on getting 17x8.5 +35 wheels on 235/45R17 tires. Will these wheels fit without rubbing at all and with as little camber as possible?
The old suspension has a tapered hole where the tie rod would drop in at. The new coilovers don’t. It sits higher than the old setup. Here’s a pic. Any comments? Is this normal ? Am I missing something ? everything ive seen says these should be plug and play. the tie rod ends definitely dont...
17x8 rims with 30 offset
This thread is saying lowest offset is 35
So would these not fit then?
I don't want to roll my fenders
Just ordered my Eibach Sportlines a few days go for my SSM 02 Type S. They should arrive first week of March. I was thinking, however, if for whatever reason my car decides to break down, I will most likely be getting an 05-06, just because I am in love with these cars... According to...
So I have a ITR sway bar which is way more clearance than a type S. I have maybe 1/4 inch clearance all around with suspension loaded. When the car gets jacked up the wheels bring the sway bar down and it hits the header.
Other than that fitment is great. Oil filter removed, never had to touch...
I have the type r front brembos, hubs and conversion. Which means I have -15mm offset in comparison to the Type S. I am looking at the Rota Grid 17x9 +42 wheels with 245/255 tires.
That basically means I would be asking if the 17x9 +27 would fit the type S with 245/255 tires?
I want to run...
I am wondering if this replacement bushing set will fit the type R front lower control arms? If so I heard there was a special tool needed to get out one of the bushings?
I am thinking about these wheels I dont want a 17x8 as that would require 235/245 tire as I have 215/45/17 right now. I dont want to stretch
My question is, currently I have a full type R brembos, hub, lower control arm conversion. The wheels on there now are +60 ET
Will the wheels in the link...