Acura RSX, ILX and Honda EP3 Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-18 of 32 Results
  1. ECU Tuning RSX
    So i just got kpro and loaded up a cal. I began recording a datalog for the way home but didn't see any graphs on the display. I thought it was normal and could only see it after loading it later but i load up the datalog and still doesn't show any graphs but does show the time of the recording...
  2. Turbo RSX
    Hi at all :) After my experience with the JRSC rsx kit on my Ep3 European Civic Type R , water/meth injection i want to try the route for the turbo. I have sell the JRSC kit about quickly and now start the turbo project. In principle, the goal is about 400 bhp, a drivable car in all situations...
  3. ECU Tuning RSX
    Setup: '04 Rsx 5 speed Kpro Injen CAI DC street header Magnaflow cat-back while datalogging a 3rd gear pull, kpro was not showing much. WOT would not cross the mid-range line, but would still have a red line indicating where it took...
  4. All Motor RSX
    I just wanted to share our awesome results from tuning the ITR this Saturday. As usual the guys at Church Automotive Testing did a great job of thoroughly tuning the Kpro. Everyone at CAT was really impressed that we broke the HP record for K20. What was most impressive is that we achieved it...
  5. Bolt-On Basics: RSX Type-S
    i am comparing two graphs to try and pin down what cause the different in power gains. both are 2004 Type R's i will however refer to them are R1 and R2 Comparison 1 R1 Specs: Fujita SRI 2.5 custom piping mandrel brands to vibrant exhaust R2 Specs: JDM Top Fuel/Zero1000 Carbon Power...
  6. Bolt-On Basics: RSX Type-S
    Dyno at Church Automotive the setup is Injen CAI, K20 crusher RH, HKS full cat-back with reflash on an 05-06 RSX-S.
  7. All Motor RSX
    here's a quick run down of the mods k20z1 in a RSX kidd racing header greddy evo2 exhaust (60mm/2.36 inches) injen cold air intake rbc intake manifold e-85 the lower line is the baseline pass after the street tune. the car was running lean from the get go. with a bigger exhaust i'm sure you...
  8. Bolt-On Basics: RSX Type-S
    Hey CRSX, I got an Injen CAI up on my car a few months back, got it dyno'd before and after (it's the only performance mod I've got...for now), and have a few questions. First and foremost, here's the dyno graph (click to enlarge), because my first question is about that. Anyway, about the...
  9. All Motor RSX
    i finished tuning this car yesterday and i figured i'd share the dyno graph with the community. so my friend made the switch over to e85 and i street tuned the car over the weekend. we then went to the dyno yesterday to dial in timing and the cam angles. here are the specs 97 civic coupe...
  10. Bolt-On Basics: RSX Type-S
    Hey guys, I went for my first dyno run on the weekend and i have questions about the results... First, here is some back-ground info on my car: -2002 Type-S, 202,000Km (approx. 125-130,000 miles) -AEM V2 SRI -Hondata Reflash #4 -Remus axleback muffler with stock piping, hi-flow cat, and I...
  11. ECU Tuning RSX
    what do you guys think of this a/f ratio? safe?
  12. Supercharging RSX
    Ok guys i just got back from my dyno pulls and iam very upset, i already have been flaming myself all day so please take it easy on me and iam sorry for opening a new thread i just dont want anybodys suggestions getting lost in the chat. So I dyno at 269.13 HP and 182.85TRQ:firemad:,with all...
  13. All Motor RSX
    I never did get around to posting this, so here it is: Mods: KPRO Buddy Club Race Header RBC Intake Manifold Hondata IMG HKS Hi Power Turbo Exhaust Injen CAI Tuning was done by Corey at Slowmotion Motorsports here in Columbus. Now I'm slowly piecing together a supercharger... :shady: Enjoy :D
  14. ECU Tuning RSX
    i have a run in my old kal, in 3rd gear with a stock header, with cat removed....... and second one i have a new map with 2 3rd gear pulls.......with the new obx v2 CTRH replica... just wanted to see if mike, wayne or someone could just do a road graph of the 1 pull before and 1 pull after to...
  15. ECU Tuning RSX
    Awhile back I was reading a thread that had a composite dyno torque graph that showed all 6 cam angles locked in. Now I can't find it. Can someone point me to it? luvmyrsx
  16. All Motor RSX
    First off, I would like to thank palmerblock for giving me the opportunity to let me host this comparison. The setup here is private and all modifications cannot be released at this moment in time. I was not in this vehicle to tune and all I did was used the data that was given to me. Which...
  17. General RSX Discussion
    Here's a couple graphs of my dyno run yesterday... I did a baseline run in 4th gear and got 190.2whp and about 137tq.! For performance mods, all I have is Injen CAI, and T1R 63mm Exhaust... I'm quite happy with the numbers! I was hoping for just over 180whp... I should hopefully be getting some...
  18. Turbo RSX
    i posted it in the other thread but figured id make my own..... greddy turbo kit with greddy fmic.... kteller 3inch exhaust and 3inch test pipe. custom 3inch down pipe. rc 750 cc injectors.. and of course kpro.. fully tuned 319 whp 240 lbs torque... 10 psi i have sold this set up and bought a...
1-18 of 32 Results
Top