Hey everyone. I've gotten a little desperate searching for help, all of the Facebook groups are useless with advice on my issue and I was hoping somebody could point me in the right direction.
Here's my situation: I have a RHD-converted RSX with an entirely original engine harness. I drove it...
My daughters boyfriend was looking under my daughters car to look at CV axles. He found the passenger side CV boot torn. So need to replace the axle. How common is it for the half shaft to need to be replaced? Any recommendations where to get CV axles. Also found a bar, attached pictures...
I started making my own ground wire system for my 2002 RSX Type S K20a2. To clear the air about these aftermarket grounding unit, the actually do make the engine run smoother, help out with gas mileage, and possibly make a couple extra HP. Taking sandpaper and removing the paint where chassis...
Selling a set of Eibach Prokit springs for Acura RSX 02-04 used for approx six months asking $140 OBO + paypal & shipping cost
Also selling two Eibach ground control springs (GC150.64.66) asking $80 OBO + paypal & shipping cost
Doing some spring cleaning and I just need to get rid of some stuff:
Ground Control Springs rate 350 lb. Can be swapped into other coilovers also
OEM header for Base model RSX
Windshield/wiper reservoir 02 RSX
Front wiper motor
Wiper switch from 02 RSX
Shoot me an offer, I'm not picky in...
Hi everybody! Quick question here. I've done my searching and have found a few people that have actually had the GC sleeves on stock struts and everyone that has blown their struts have dropped 2" or more. I cant find anyone that has dropped it less than that. I read somewhere else on this site...
Selling some Eibach ERS springs.
100 shipped a pair... All springs are 2.5". The lengths and rates are printed on the actual spring (see pics). For example a 0800.250.0500 is an 8" long spring with a 2.5" diameter and 500 pound weight.
These measurements were from the bottom on the center cap to the inside fender lip (the part you would roll). Anyone running koni yellows this low?
Right now it's about one finger rear and two finger front wheel gap.
Up for sale is Sun Auto's Hyper Ground System. It is the small universal kit (On Sun Auto's website it says this size is to be used in the RSX) and silver in color. The company is now out of business. It was never installed and just collecting dust out in my garage. It comes with all the...
just cuious which brands of race headers give us the most ground clearance after install. My neighborhood and work have an awful amount of speedbumps and Id hate to invest 500-1k to just destroy it while cruising the parking lots. The few Ive been checking out are the kiddracing, skunk2 alpha...
Fuck you khoa
Andy 313 <-----disappoint
fightthisfight 247 <-----still mad at me
AzianK 228 <-----more disappoint than Andy, and also a bitch
White_02 151 <-----new Prezes?