Acura RSX, ILX and Honda EP3 Forum banner

hanging

  1. Problems & Solutions RSX
    Just noticed this plastic line attached to a bracket dangling from my undercarriage. Any ideas on what this could be?
  2. Problems & Solutions RSX
    Hello, my 2006 RSX has some slots underneath the front lip that are supposed to be secured but currently are not causing the plastic piece to warp in the middle and hang down. Hopefully that makes sense, I can't figure out how to describe it at all but here's a picture I was wondering what...
  3. Problems & Solutions EP3
    I was looking at my rear wheel yesterday and looking through the wheel well I saw a cable with a connector on the end just hanging there. I'm trying to figure out what this connector is. I'm thinking it's a connector for a trailer because I can't think of any connector that would be down there...
  4. Problems & Solutions RSX
    So for the past 2 days my revs at idle after coming to a stop would hang around 1500rpms. It normally does that but just for a second or two not for 20 or so seconds as it was doing recently before dropping to around 1100-1000rpms. My car normally idles around 750-800 rpms so I knew this was...
  5. Problems & Solutions RSX
    I'm a total noob and a long time lurker. I felt a slight grind and then a rattle coming from under my car this morning so I stopped and took a picture of this. Can anyone help me identify what it is and how I can reattach it?
  6. Problems & Solutions RSX
    Hey all, quick question here.. I have noticed for about the last month or so that my RPM's will hang a bit when I have decelerated to idle. Basically, whenever I slow to a stop.. My RPM's will hang up at about 1,700rpm for about 3 or 4 seconds once I've fully stopped.. Before coming back down...
  7. Suspension, Chassis & Brakes
    so im putting on these coil overs on my rsx i did the rear and now im on the front and im putting it back together but when i try to put those 2 bolts back on that hold the rotor to the thing that holds the spring i cant seem to get it all the way on and my rotor is kinda just hanging there. am...
  8. Problems & Solutions RSX
    so im putting on these coil overs on my rsx i did the rear and now im on the front and im putting it back together but when i try to put those 2 bolts back on that hold the rotor to the thing that holds the spring i cant seem to get it all the way on and my rotor is kinda just hanging there. am...
  9. Problems & Solutions RSX
    ok i've been doing some reseach and i thought that the smell of burnt eggs was usually normal because thats what my cars been smelling like but realized i should get my car checkd. i hear this rattling noise when i start my car so i look under my car and see my catalytic converter heat shield...
  10. Problems & Solutions RSX
    ok i've been doing some reseach and i thought that the smell of burnt eggs was usually normal because thats what my cars been smelling like but realized i should get my car checkd. i hear this rattling noise when i start my car so i look under my car and see my catalytic converter heat shield...
  11. Problems & Solutions RSX
    Does anyone know how to adjust the passenger door? It has come out of adjustment and not closing easily anymore. I just replaced my door gasket/weather stripping due to the door tearing it near the latch. Any help is appreciated.
  12. Everything Else
    For sale is a moving picture wall hanging with sound. I purchased this wall hanging a few years back but I have since ran out of space so I must sell it. The wall hanging is in EXCELLENT condition. It has been cleaned regularly since i purchased it. The picture is of a lighthouse next to the...
  13. Problems & Solutions RSX
    What can I do to fix a low hanging exhaust? I have a power getter paired with a Toda RH and my car isn't even that low but I scrape rolling over speed bumps. There's about a 2 inch space betwen the car and top of the piping. Is there anything I can do to get the exhaust to hug the underside of...
  14. Problems & Solutions RSX
    So I picked up this 5zigen fireball exhaust and it was a little bit bent by the original owner. I tried to bolt it up and it fits but its very tight and low to the ground right after the cat. I had to push the axle back really hard to connect it to the mid pipe. In the pictures you can see...
  15. Exterior Mods RSX
    I saw this thread on other forums and wondered if anyone on clubrsx hung anything on their tow hook.
  16. Problems & Solutions RSX
    I recently installed an OEM exhaust again, and I remembered from my previous OE exhaust, that it hung really low. I know this is common for a lot of RSX's. When I did the install, I noticed that the rubber isolator that had the most give to it, was the front one near the catylitic. I...
  17. Mid West
    Anyone know how much of a chance I'd have of them dropping my speeding ticket a little? 68 in a 55.. I swear I actually thought the speed limit was 65, that was the last sign I remember seeing. I wasn't flying past traffic or anything, just puttin' along in the right lane. :(
  18. Problems & Solutions RSX
    k i got the lips install from a shop like a 1yr ago and recently i notice that both sideskirts are like hanging lower and outwards, all i see holding the sides are 2 tapping screws at front wheel area, 4 black push in clips at bottom, and they used this z metal bracket at the rear portion. sadly...
  19. Bolt-On Basics: RSX (Base)
    Hi guys/ girls, any of you have the same issue with your stock exhaust hanging low? The tailpipe and tip fit well, but it looks like the mid pipe comes out at a strange angle from the cat, and the rear resonator as well. If you crouch beside the car, you can see the entire mid pipe sitting...
  20. JDM Only RSX
    :confused: well, lately i've been seeing a lot of peeps with objects like (key chains, lil stuffed animals, etc.) hanging from the tow hook or hanger in the rear of the car. is this considered jdm?? I personally think it's whack but maybe its just me...
Top