Acura RSX, ILX and Honda EP3 Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-17 of 500 Results
  1. Suspension, Chassis & Brakes
    Long story short, my suspension has gradually become worse, I feel bumps much more, and the car hits so hard over bumps. I decided to go ahead and spend a little extra and get koni yellows. Well they're on the way, and tonight as I was changing my transmission fluid I saw that my ep3 has kyb's...
  2. Suspension & Brakes RSX
    Tein Camber Plates Barely used (in fact, only the Right plate was used, as we were troubleshooting a suspension issue). Includes all original hardware and instructions, plus an 18mm--->14mm sleeve that will take up some of the space between the shaft of a Koni strut and the inside of the...
  3. Want To Buy or Trade RSX
    Looking for a set of koni yellows for rsx 05-06, must be able to ship to Toronto or be located near Toronto . Also willing to look at a full out coilover setup, looking at mugen SS, aspec, or whatever give me your offers. Thanks
  4. Suspension, Chassis & Brakes
    I purchased a set of prefabbed 8611's in stock RSX housings off of the Marketplace on here in October. I finally got around to being able to Autocross on them, and find that there is play internally in the housing. The gland nut is tight, but the insert can wiggle around, causing some dynamic...
  5. Want To Buy or Trade RSX
    Lmk what you got! Txt me at 786 308 0673 Thx..
  6. Problems & Solutions RSX
    I replaced my Konis this weekend, but now i got heavy vibration / shaking when either accelerating or going downhill and letting off the gas. Its more noticeable from 50-80mph, if i hit the gas at those speeds it's like a thudding ( like the wheel wants to come off ) sound that i can feel...
  7. Problems & Solutions RSX
    Hey, Searched to see if anyone else had this problem and cannot find anything. i cut around the circumerence of my oem strut, 40 mm from the top of my strut housing for the front strut. I drilled the hole in the bottom, and now the koni insert doesn't seem to want to go in anymore. There are...
  8. Suspension, Chassis & Brakes
    Hey CRSX. I am planning on running my 06 Type-S on 255/40 r17 Ventus RS3 V2's at the track and at autocross. I recently purchased some Koni Yellows and was wondering if you all could answer some questions. Here they are: 1.) What spring rate would be good for a slight drop in ride height (.5...
  9. Suspension, Chassis & Brakes
    Hey, I've searched the forums and it seems hard to find an answer to my question. I'd like to keep the stock springs and replace the oem struts with koni yellows since my oem ones are blown. I can still run stock class in autocross with aftermarket dampers and oem springs, but I was wondering...
  10. Suspension, Chassis & Brakes
    Hey guys, I have an rsx-s 05 since almost a year and I'am already boring of the stock stance. I am doing 90% street and 10% lapping/track school. I would like to know what would be the best combo with Koni yellow struts. I am thinking going with Koni/GC or Koni + lowering spring like Tein or...
  11. Suspension, Chassis & Brakes
    Hi Everyone, I was wondering if anyone knew if a pair of front base model konis will work on a 02 type-s? I keep finding different answer online. Hopefully someone has experiencing in dealing with this. Any help would be appreciated. Thanks :fistbump:
  12. Suspension, Chassis & Brakes
    What's up guys, I just bought some used rear koni yellows for my rsx. The stock upper strut mounts don't fit the konis. Does anyone know which aftermarket strut mounts I can use? I can seem to find any info online
  13. Suspension, Chassis & Brakes
    These measurements were from the bottom on the center cap to the inside fender lip (the part you would roll). Anyone running koni yellows this low? Right now it's about one finger rear and two finger front wheel gap.
  14. Want To Buy or Trade RSX
    Looking to buy rsx type s rear koni shocks. Must be in good working condition and must be willing to ship to 55119. LMK by pm or reply below. Thanks.
  15. Suspension, Chassis & Brakes
    So my Koni's are blown and I havent had them very long, checked out the prices for a rebuild and its about 115+parts per strut. What is the closest full coilover set that handles like the koni/gc sleeve set up that lasts. My koni's lasted about a year/15k-ish miles. I was reading up on buddy...
  16. Suspension, Chassis & Brakes
    Hi Everyone, I just purchased a set of rear knoi yellows that and installed them with my eibach pro-kit. Stock springs in the front. When I added the konis to the set up it lowered the rear end about a 1/2 inch or more. I've done some research and saw that some people have added a coil over...
1-17 of 500 Results