Acura RSX, ILX and Honda EP3 Forum banner
main
1-17 of 66 Results
  1. Problems & Solutions RSX
    Hey everyone. I've gotten a little desperate searching for help, all of the Facebook groups are useless with advice on my issue and I was hoping somebody could point me in the right direction. Here's my situation: I have a RHD-converted RSX with an entirely original engine harness. I drove it...
  2. Problems & Solutions RSX
    Hey guys I’ve had a weird humming sound coming from my belt accessories. Well this morning the belt squeaked all the way to work so I popped my hood and saw that my main power steering line has fluid on it, my reservoir lost a 1/4 fluid so it’s a slow leak since I filled it up a couple of months...
  3. Problems & Solutions RSX
    Hello, So far i have located: 1. Fuel injector to valve cover stud (formally the intake manifold) 2. Negative battery to chassis 3. Passenger motor mount to chassis 4. Transmission one that loops to i think the positive battery to the chassis? 1. Am i missing any? 2. Is the "Passenger...
  4. Engine Building & Design
    Hello all. I took a bit of time a couple nights ago to double check my clearances I was getting on my mains in my rebuild. I used the block and crank codes to get my colors and bought all brand new oem bearings. My plan for the motor is going to be a high compression N/A motor with high lift...
  5. The DIY Garage RSX
    I am replacing the clutch and flywheel soon. There is tons of good information that I have searched for and found but I have not found a definitive list on what I may as well also replace while I have it torn apart. I have seen a mention of a part here or there and am just trying to get as many...
  6. Engine Building & Design
    Okay, after i put my crank in and plastigaged the bearings i ordered according to the codes on the block and crank, i had readings telling me the bearing were too thin (this was without any lube on my main bolts). When i rechecked using APR Torque assemebly lube, Im getting reading from the...
  7. Problems & Solutions EP3
    Car won't start. Nothing, completely dead. No guages, no lights, nothing. I suspect I blew the main relay but have had some trouble finding a part # for it. Anyone have a part # for it? And maybe a schematic of where it is?
  8. Problems & Solutions RSX
    Is the rear main seal common to go bad? I just turned 114k miles and noticed a small drop of oil on my driveway. I got a flashlight and found the leak to be coming from what looks like a weap hole on the trans? Not sure if its the rear main or the axle seal because its hard to see at night. Any...
  9. The DIY Garage RSX
    I'm planning to install a kill switch but I'm not sure of which wire is which just need a little bit of help, excuse me if I posted this in the wrong place I'm new here.
  10. North East
    Hey all, just wanted to put this out there to anyone interested in a car meet my friends are holding in Farmingdale called "Nights on Main". The meet originated last year and was a huge success after the downfall of "Occupy Glen Cove". The meet is on Main Street in Farmingdale, the same strip...
  11. Engine Building & Design
    How far do u press in the rear main seal? Do you make it flush with the edge or press it in until it stops? Pics would be nice thanks
  12. Problems & Solutions RSX
    Backstory: 2002 RSX Type-S has sat for almost 2 weeks. Tried starting it today, vehicle had no electrical power whatsoever. Keyless did not respond, no lights, nothing. Friend came over, we tried to jump-start the car. Connected the positive cables, but as soon as I touched the negative cable to...
  13. Want To Buy or Trade RSX
    pm me with price
  14. Transmission & Drive Train RSX
    Whats up CubRSX. I'm pulling my tranny to replace my rear main seal. While its pulled what else should I replace? I had my clutch replaced about 6 months ago and just put an exedy oem style clutch but forgot to replace other things while it was pulled. My tranny has 140k miles on it. Any...
  15. Problems & Solutions RSX
    Hello All, First gear started making a nasty grinding/click-clank sound today and hasn't stopped. It only happens when driving in first gear and stops when I push the clutch in. I did some research and from what I've found from similar problems was that it's either the Input Shaft Bearing or...
  16. General RSX Discussion
    I took my RSX S-Type into the Acura dealership today because the Air Conditioner is cutting off. It'll work for a while but then it stops working for a long time then may come back on for a little while. The Acura Service Department said that they checked the AC clutch, compressor, and...
  17. Want To Buy or Trade RSX
    Im looking for the following parts: Clutch master and slave cylinder, Main power steering line. Parts are for 02-04 RSX-S
1-17 of 66 Results
Top