Hi guys, this is my first post on the forum. I have an 02 rsx type s that has a cat back exhaust and sri. I recently got a hondata because i found some 06 tsx cams that i found in my local pick and pull. I then ordered an rbc intake for it. I searched for a while and couldn't really find...

Does anyone have a good calibration/map for a 2006 Type S with RBC manifold and typical bolt ons? I have CAI and RH.. I am using the stock TB. I was quoted $500 to have the car tuned for the RBC, which imo is way too high.. If not, does anyone know a good e-tuner, or street tuner near...

Uused, p.n. 37830-PGK-A01 $40 shipped

Hello Admittedly I am new to KPRO. I have had it on the the shelf for a couple of years, it is the most current version. I have an RBC I would like to install since I am doing the BIG3 upgrade I thought now might be the right time. First Request: I am in need of a map with Injen CAI and RBC...

I have an 04 type s with 05-06 cams. I'm putting my cat back on for smog and need a stock 05-06 map since I don't have any mods other then a race header.

Hi guys, haven't touched my kpro in YEARS. I've driven on 94 oct for last 7 years but now gas is getting to be a little too expensive in my area. Im wanting to back down to 91, what should I change in my map? my mods are I/H/E/intake manifold. Im thinking stepping down ignition slightly across...

I just swapped in a K24A1 with forged internals and I previously had a K20A3 Turbo. I will be getting the car tuned as soon as its running, but I need to be able to drive down there (about 30 miles). Fuel system is the same; same 650 injectors. Same turbo as well. And I have KPro Question: Am...

Two different part #'s 2004 part #37830-PGK-A01 Kseries part references this is for both 04 and 05 According to oem acura parts it is not the right part for my car 37830-PNC-003 Does anyone know if the 04 will work for the 05? The price difference is huge and I would like to save some coin...

I just bought the car about a week ago. As it was day time when I bought it and everything seemed great I didn't notice that the horn, fog lights, and the map lights in front of the sun roof don't work. I really think is a fuse but this car didn't come with a owner's manual so I'm not sure what...

I was wondering if anyone has a base map I could use for. Buddy club header/exhaust Tsx cams 06 Rbc ported to74mm matching tb Injen Cai Also should I upgrade to 550cc injectors? I looked on the hondata website for base maps and I couldn't find one with ported rbc and cams

the past 3 days ive been having trouble with my car. out of nowhere, it wont start anymore. i have tried many things like a brand new map sensor, checking the wiring, adjusting valves, ensuring timing is correct, cleaning IACV and throttle body, replacing throttle body gasket, confirming...

This may be a lot to take in but allow me to Explain my problem and attempted solutions. Car: 2002 rsx type-s Modifications: -jrsc supercharger at 9psi - OBX race header - stock catback - snow meth injection Problem: the MAP sensor is reading 10psi at idle. It won't allow the car to run for...

Ok installed the skunk2 IM on my 06 RSX type S and I'm having problems with it almost stalling. I figured it was the MAP sensor. My question is can't you Tee off the only vacuum line to the MAP sensor or do you actually need to drill into the manifold?

I'm just about ready to hit the dyno but the base map in Kpro isn't working out for me. If I drive the car any distance and push in the clutch as I come to a stop, it dies. It looks like it's going uber-rich off throttle even under no load. I won't make it round the block, much less a few...

Just bought an emanage ultimate! Pretty excited! I'm about to boost the car, but want to test it out first, would it be fine if I ran emanage without tuning it? The person I bought it from said it does have some maps on their but its new never plugged in/used. What do you guys think? Thanks

Just finished K24A2 into my 2006 Rsx S Does anyone happen to have a map I can try out? I just need to get the car on the road to put a few break in miles on the new clutch. Then I'll be taking her in for a full tune. MODS LIST: 07 k24a2 RBC GT2835 turbo w/ cast manifold 2.5 downpipe w/ stock...

selling lots of stuff that was in my garage for spare parts of left overs! sorry for the name tags from another site :P K20A2 short block all oem, working like a charm, perfect to replace a busted block 500$ shipped K20A2 PRB cylinder head all oem, perfect working order complete with valve...

I've looked for a base map on here and on the Hondata forum and I cant find a similar map. Everyone has I/H/E but no one has just a race header map. Please share if you have one. I'm not looking to tune till I put on an RBC, 05 cams, and a 05 exhaust. Currently running Kmanager's basemap with...

Do I need to go aftermarket MAP and IAT sensor for a greddy/HKS turbo kit? Power levels around 300-350whp. I see a lot of guys stepping up to 3/4 bar MAP sensors. Found KTuned for around $100 shipped. What about IAT sensor? Will oem be ok? Thanks

where do i buy the map sensor adapter, my jrsc never came with one and i cant find it anywhere