Acura RSX, ILX and Honda EP3 Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-17 of 18 Results
  1. Problems & Solutions RSX
    Hey everyone recently my check engine light came on in my 03 base auto. After scanning I received the code p1077 for the imrc sensor, which I replaced. Still I have my check engine light on, but now with the code p0661. This is the code for low voltage going to the imrc sensor right? I've...
  2. Problems & Solutions RSX
    Have 2004 RSX (base) with 173,000 miles on it... Just replaced battery last week....thought things were OK again..... I just went and filled with gasoline. When I restarted car, I noticed the engine malfunction light came on. I looked in manual and it said it related to emission control...
  3. Bolt-On Basics: RSX (Base)
    Should I replace the whole assembly or just the sensor The code reads intake manifold tuning valve control circuit low
  4. Problems & Solutions RSX
    Hello CRSX, I have recently come across two problem codes on my car: P0661 - IMRC Circuit Voltage Low P1077 - IMRC Valve Stuck Short (Low RPM) NOTE: IMRC = Intake Manifold Runner Control Now I have already checked the helms manual and found a trouble shooting procedure. But I have three...
  5. Problems & Solutions RSX
    Hi, I have problem code po661 and p01457 on my 2002 rsx. The car is a base model manual. any help on fixing this please?
  6. The DIY Garage RSX
    Currently testing a simple circuit prototype that allows the use of different intake manifolds on the base RSX without throwing engine codes. The circuit can be made in under an hr with a soldering iron and $11 in parts from amazon, ebay, radioshack or other electronic component retailers. I...
  7. Problems & Solutions RSX
    I have a 2002 RSX base model I just purchased last week. The other day my check engine light came on. Yesturday (January 1, 2012) I had a friend of mine plug in the diagnostic tool and scan to see what's happening. The trouble code came up as "P0661 IMT (IMRC) Circuit Voltage Low". We erased it...
  8. General RSX Discussion
    I have a 2002 RSX base model I just purchased last week. The other day my check engine light came on. Yesturday (January 1, 2012) I had a friend of mine plug in the diagnostic tool and scan to see what's happening. The trouble code came up as "P0661 IMT (IMRC) Circuit Voltage Low". We erased it...
  9. Problems & Solutions RSX
    I hope I can get some help on this, and I have searched and read all the previous posts. I had my CEL pop on the other morning. For the past few month or so I have had a problem with it not wanting to start, takes 3 tries or so, and then fires up no problem. Battery and charging system check out...
  10. Problems & Solutions RSX
    okay guys so couple month ago i broke the purge control valve sol, so recently i purchases the part n i put it on like a week ago and the engine light is still on, i also try to reset it with my scan tool but its keep comin bak on, any help would be appreciate, thanks
  11. Problems & Solutions RSX
    //
  12. ECU Tuning RSX
    //
  13. Problems & Solutions RSX
    Check engine light recently switched on and it was P0661. As I don't have much expertise with cars, I took it to the dealership to get the job done. Freaken cost a whole 250 bucks -.- Nevertheless, I'm glad the problem is fix. I take my car back and now, a month later, check engine light...
  14. Problems & Solutions RSX
    hi there all, I need and expert option,as this has been an ongoing issue??? I got this code,since last Dec 2009,and was unaware that my car might of been under warranty(emission 7yrs), unfortunately was not fixed or looked at until Jan. 2010.. My first ASE independent mechanic replaced the IMRC...
  15. Problems & Solutions RSX
    Somebody can tell me where is locate this sensor? A pics would be nice too.... I have this code P0661: Intake Manifold runner Control Valve position sensor Low Voltage P0662: Intake Manifold runner Control Valve position sensor High Voltage Somebody have an idea how to fix this... First...
  16. ECU Tuning RSX
    dunno? i got this error with the base factory cal. i have a k20a3 (obviously) and mods are as follows weapon r ignition equalizer pulse plugs (going out and ngk will be going in) injen cai dcrh skunk2 catback so any ideas on whats generating this error? im a lil confused. i expected the o2...
  17. Problems & Solutions RSX
    I Dont Know Its Says Its Intake Manifold Tuning Something So What You Guys Think I Should Do Take It To The Dealer
1-17 of 18 Results
Top