I have newbie question also i search the treads couldn't find an exact answer.
i have a 2003 si trying to install some energy suspension bushing. My question is regarding the trailing arm my local shop is saying my looks different from other civics.
he doesn't know how to...
Just swapped my motor, i have a boosted setup, and went to start it. THe car has been sitting for over a year and finally finished everything and went to start it, and it only turns over. I have good fuel pressure, just no spark at the coils.
Checked the fuses behind the dash, under driver...
I was changing out my galled cams fo some.skunk2 stage 1 cams. When switching intake gear over, we opened up the gear to clean it out. When we opened it up, we lost one of the retainer pins, it shot somewhere and it's gone. I either need an old beat up cam gear, or one of the pins.
I was servicing my brakes today and noticed a couple of the caliper slide pin boots were torn. I've never replaced one of these before and I didn't see replacement instructions in the service manual so I need to know how to replace them and I need to know if these are the boots I'm looking for...
Well long story short.. went to change out all four brake pads and when i got to the passenger rear i notice the caliper boot that goes over the piston was somewhat torn. I didn't test the pin to see if it was functional and was in a rush, so i attempted to put the caliper back onto the rotor...
Im having issues with my k20a swap in me 97 ek.
1:The battery keeps dieing and when i remove the terminals ona good battery the car imediatley dies. Benched the alternator at autozone its good as new
2:Before the batterey dies my gauges go nuts and radio goes on and off as if its a bad...
Hey all, if theres a cf hood that I want that already has sparco pins, but I want to install aerocatch on em, aside from cutting out the larger "hole" for the aerocatch pins themselves, I figure it should be straightforward.
I guess what I'm trying to say is that I see that location does matter...
Looking for a the harness that plugs into the eBay fog light switch,
my switch looks like this
need the harness that plugs into it
paypal ready asap
Does anyone have any recommendations for how to figure out what the pin-outs for the eBay fog light switch (5 pins) is?
I did my fog lights totally custom wiring and didn't use any of the harnesses or anything, and did it without a switch but wanna add the switch in now.