I have a Mugen kit that's fiberglass and I'm torn between selling it and buying the urethane kit or jus painting the fiberglass and putting it on. I'd like to know what anyone thinks I could get out of the fiberglass if I sold it and what are your opinions are on each type. Thanks! :)
So I pulled my steering rack a few days ago to replace the slider. When I had it removed I noticed the drivers side bushings looked a lot like the older EF/EG/EK bushings. I ordered a set and sure enough they are close enough to fit.
This only replaces the drivers side bushings, however the...
Have an Wings West 6 piece polyeurethane kit with factory OEM bumpers, painted in Silver and is complete.......Looking to sell as a kit, not part out, parts are full bumpers and all
Front Bumper is full bumper with lip and grill(OEM Honda bumper)
Rear Bumper is full bumper with lip(OEM honda...
I have an annoying rattle sound coming from the engine. (timing chain i think) it happens in almost every start up and cruising at low rpm any gear with low throttle. after around 2.5k rpm the engine sounds and performs like normal. ive already checked all the drive pulleys and belt. the sound...
Found this lip, its cheap and looks like it may look ok, in my opinion.
Anyone have pictures of an RSX with this lip?
I haven't been checking up on dc5 parts lately since being overseas and driving a nissan, but I was just lurking on ebay usa, since you guys have been talking about the poly mugen replica front lips- I came across this lip and was wondering if anyone has it? It looks like it is nice and flat and...
They actually made a poly mugen front lip wanted to know if anyone purchase it...
I have for sale a ingalls rear camber kit, i bought it off clubrsx and never put it on due to getting on installed for free. Im lookig to get atleast 120 for it. It is out of the packaging but its still brand new.
Im fixing my suspension and need to get an alignment and fix my tire toe angle.
Bought the car like that and my tires have been getting worn out due to the tire toe.
Im currently dropped on Eibach Sportline lowering springs and have SKunk 2 LCA's, 24 progress RSB..
I want to get camber kits and...
Got some parts in my garage I'd like to get rid of. Located near San Jose, CA. If paying via paypal add 3.5% for fees.
OEM 04-05 Civic Si 17mm Rear Sway Bar & Bushings - $30 + Shipping
New Energy Suspension 15mm Poly Rear Sway Bar Bushings - $15 Shipped (but greased up by mistake)
i know ingals and spc make one of the best camber kits but what would you guys suggest? im looking to get an aggressive camber.
and what would be better? rubber or polyurethane? and why?
would ksport camber kit be good?
I am in need the following for a 2002 civic si ep3 :
silver pocket for the spot below the radio
rear seat brackets
rear seat belt receivers
coolant overflow cap
shifter trim plastic ( no hazard switch needed or shifter boot)
are they any good? would you reccomend them? anyone on here have it?
im looking at this one here
if not any reccomendations? links?
what are the best or better ones made out of...