Is the H port the one located close to the drivers side and the L port closer to the middle towards the cars cabin? This is for a 06 Base. Just want to make sure I didn't place the caps on the wrong ports.
Sent from my XT1080 using Tapatalk
Ok I'm in the process of installing my ktuned steel oil pan and noticed that there is 2 spots that I see that oil comes from that are not covered with the k tuned oil pan. Check pix for reference. Tnx for any help.
Is it possible to remove the inlet and outlet coolant ports where the hoses normally go? Speaking of the hose that goes from the t stat to the firewall and the one that goes from the firewall to the head. I believe they are connected to the whole heater core but I do not want to remove my dash...
I'm pretty much new to the site and my first problem that I have from my 02 SSM RSX Type-S is that both of my car charging ports are not working. When I plug my phone charger in the port(s) it doesn't illuminate. Any tips?
When i remove the blower, after replace the ball bearing and after ported them, i want to plug the discharge ports with the JB weld because weld with a TIG solder can damage the housing of the rotor.
Anyone have try to plug this discharge ports??
The JB weld compound is this ...
I'm selling my Karcepts adapter with vaccuum ports.
It comes with the bolts to attach the adapter to the intake manifold as well as longer bolts to attach the throttle body to the adapter.
Paypal is [email protected]
I can ship out same day if I receive money before 3pm M-F...
For Sale is the RBC Karcepts Intake Manifold Adapter with Vacuum/Boost ports for your FI people :thumbsup: What you see in the pics is exactly what you will receive.
SOLD TO Spoon_Fed88
Hey guys, i have few hdmi splitter for sales, all of them are brand new. it also come with remote control. Fully supports full HD resolutions including 480P,576P,720P,1080i and 1080P.
Selling for $21 shipped each. pm me or email me at [email protected] if interested.
Here is the picture...
alright, someone with a IM look at, or someone who can remember it vividly might have to set me straight on the following...
while doing my ITB research and designing a new flange, i came across those little holes above each intake port, in addition to a 8mm or so hole between runners 3 and 4...