Acura RSX, ILX and Honda EP3 Forum banner

pressure

  1. Cracked my oil pressure switch mount, need help

    Problems & Solutions RSX
    I was changing my oil pressure switch as it was leaking but when I was putting the new one in I overtightened and cracked where it suppose to mount , any ideas how to fix ( weld it shut? JD weld , use a bolt to plug it ? I have limited funds as I'm a student but it's also my fault why this...
  2. Fuel tank pressure sensor

    Turbo RSX
    Took the fuel pump assembly apart to figure out why I get poor fuel delivery at close to a 1/4 tank of fuel. I also wanted to see how the pump was modified for the return. They put the output out the top in the middle and submerged the in tank pressure sensor. I can't get the Kpro to fire on...
  3. Help please. Leaking oil from oil pressure switch ?

    Problems & Solutions RSX
    Ok so I was doing my oil change today on my 06 rsx and after I was finished , started up the car and the car started leaking oil everywhere . Car was on for less than 30 seconds and all the oil came out that I had just put in ... I popped the hood to find this out of place (first image ) after...
  4. K20A2/K20Z1 Low Oil Pressure

    Problems & Solutions RSX
    Long story short - I have a 2006 type S that I bought from an owner who decided to continue to drive the car with an overheating motor, resulting in both the head and the block warping. To sum things up, I kept some of the bolt ons from the motor and went ahead and found a good deal on a K20A2...
  5. Oil pressure and timing tension

    The DIY Garage RSX
    So, my oil pressure light started flickering. Also around the same time, I started hearing a noise on the right front of the engine. At first, I didn't think the two were associated, I thought it was a bad OPS and a heat shield making a racket. So I changed my oil pressure sensor and removed the...
  6. For those who have changed an Oil Pressure Sensor

    The DIY Garage RSX
    Kinda embarrassing, but i didnt pay attention to the old Oil pressure sensor when i removed it. The new one is not bottoming out. I am not sure if it is supposed to or not. I have about a 1/4 inch gap between the base (flat part) and the block. Although its definitly got more than the 16 inch...
  7. Sold sold sold

    Southern California For Sale: Local Pick-Up
    Sold
  8. P2646 for Oil Pressure Switch

    Problems & Solutions RSX
    My car throws this code every time it rains really hard. Maybe because I have no fender liners and the part is clogged, IDK. I know the part is 37250-PNE-G01 and it’s actually fairly easy to change out. What I wanna know is I’ve noticed my car is having issues shifting. It’s an automatic but I...
  9. Fuel pump primes but won't build pressure!?

    Problems & Solutions RSX
    I have to go to work in 4 hours and I've been stumped all week on this. someone please throw me a bone. This all started when I cleaned up my iacv, car ran fine before this. I have kpro if it helps, but I have no idea how to use it yet. Came with the car and I've been too busy so far to toy...
  10. High pressure on upper radiator

    Problems & Solutions RSX
    What's up guys, I have a problem, I went to clean my IACV and lost a lot of coolant and forgot to top off the coolant. Ran the car like that for 9 miles (home to work) and as soon as i parked i saw that the temperature gauge was three quarters of the way to reaching the red top of the temp...
  11. Recommended tire pressure

    Wheels & Tires
    Hello everyone. Just wanted to share a useful resource for those looking to find recommended tire pressure settings for their car model. Recommended Tire Pressure
  12. NEED pigtail for oil pressure switch BASE MODEL ONLY

    Want To Buy or Trade RSX
    It is part of the main harness and would just need cut off leaving extra wire and shipped plugs into #13 on the back of engine at the vtec solenoid thanks
  13. Low oil pressure and p1259

    Problems & Solutions RSX
    Hey guys I'm new to the forum. I recently just purchased an 03 rsx base model. The motor in the car had a bad connecting rod so I replaced the motor with a used one that had 75k on it. Now I'm getting an error p1259 vtec malfunction and at idle I'm getting a flashing oil light. ( idle is around...
  14. Transmission oil pressure switch(es)

    Transmission & Drive Train RSX
    Hey guys, I'm new here looked all over google and clubrsx and i havent found a solution or answer to my problem any help would he appreciated! Recently ive run into a problem with my 03 rsx, started when it was snowing out. The car started shifting very harsh, few days later I drove it again and...
  15. is this pressure plate reusable?

    Transmission & Drive Train RSX
    i have a used ACT HD clutch kit awhile back from taking it off due to throw out bearing being toasted and replace with c.c stage 2 kit. now this 2nd clutch of another TO bearing is toasted again. my question is does this PP looks okay to use again? are those pp fingers normal wear?
  16. CEL says replace VVT pressure switch but not running any different

    Problems & Solutions RSX
    Hey guys, I've had many problems with my '06 base that I've been able to fix thanks to your threads and comments. But now I feel I need to post. back in May I had an issue with my Vtec that I solved by replacing my oil pressure switch, I never got a code though. (Troubleshooting thanks to this...
  17. RSX AC gains air pressure too fast to hold freon

    Problems & Solutions RSX
    So after smoke came out all the vents AC stopped working within 5 mins. Eventually get around to trying to charge the car, says its over charged, took longer than normal to release air before eventually building back into the red before successful Freon intake, any ideas? I was told maybe AC oil?
  18. Help no brake pressure at all after bleeding

    Suspension, Chassis & Brakes
    So my brakes system went dry because one of my calipers were leaking fluid. I had that changed but the shop said they couldn't bleed it because the master cylinder went dead as well. My bro and me thinking it was BS tried bleeding it using a Motiv power bleeder which bled the whole thing...
  19. 2 Small Minor Newb Questions Related to Oil Pressure Sensor

    Problems & Solutions RSX
    Hey guys, Just 2 small question. So I just ordered in a new oil pressure sensor switch since I've been getting the P2647 code. Well, question one is, do you guys take off the... I think it is called heat shield? That metal plate surrounding the plugs in that area when trying to remove the...
  20. Power steering pressure line hose replacement

    Problems & Solutions RSX
    New to the club and first RSX. I would like some tips of how replacing the power steering pressure line hose. Ive been looking for some information but nothing specific that could help me. Any tips of how to do it would be amazing. Its leaking a lot of oil and i need to replace it as soon as...
Top