Search Results for ‘problemneed’

I was just on my way to work, and all of a sudden I pressed my clutch and it didn't release back, and I couldn't put it into gear. Does anyone know if this sounds like I need to replace my clutch? I never have since I've bought the car. Basically there's no pressure on my clutch anymore

ok so i did the DIY install aftermarket sub/amp to the stock bose system. i have one problem tho. i installed and wired everything up but everytime i turn the volume all the way down the sub is still hitting very soft and low in quick punches, it is very low but i am not at ease with this haha...

I am trying to reset my srs light. When I plug up the scan tool it says their is not signal on the front left and right side impact sensors. Now the scan tool will erase them and the srs light turns off then comes right back on and it throws the same code again. Obviously there is a problem but...

This problem regards the OBD 2 connector.. ok in my 1996 Acura integra RS.. manufactured in the late 1996 may and further. made in the U.S. i have taken apart the whole center dash assembly. and this sucker is no wheres to be found. wondering if anyone has seen it else where.. unless its...

i wasnt getting any replies in the N/A forum so i'm hoping for som feedback here... Just got my DCRH, EVO 2, ESMM's, and Hondata IMG in today. I have a problem, and the problem is that everytime i start off in first gear, the header seems like its making a cracking/knocking noise, i didnt bend...

I just got my Fiberimages CF hood today and i ran into a problem putting it on. Everything went smoothly until it came time to actually latch the hood on. It seems like theres too much tension on the safety latch and its not catching. I pushed the hood as hard as i could until i felt itll...