Search Results for ‘pull’

I ran into one out in the desert in so cal last weekend going through palm springs area. I didn't realize those things have a small turbo on them. Anyways, had 3 really good pulls from the stop lights with one of them. The Focus ST got me from the start, I think they have about 80 lbs more...

As the title says, i haven't made mind up about which would be easiest to do. my buddies recommend to just pull the engine and replace it that way, but with research it makes it seem like pulling the engine from the top is a hassle and I only have a cherry picker and i cant really just drop it...

Blinking CEL happens while car is hot, in VTEC, WOT. Usually topping out 3rd or 4th gear will cause it to happen. CEL blinks anywhere from 3-20 times then goes off. CEL has always gone off and has never stayed solid (even after getting blinking CEL several times in same drive). Very Very...

I want to install an ignition kill switch with a relay wired to the Brain armed negative output , would a 30/40 amp relay be fine? Or I need 40 ?

Hey guys, This will be a bit lengthy, so hang in there. I purchased my RSX Type-S this past summer. The car had 187,000 on the clock, and allegedly, the previous, previous owner had installed a new clutch. I had no physical proof of this, although i did have a good, firm clutch pedal. The only...

Hey guys, so i'll just jump right into it. I have a 2001 Honda Civic, with a K24/K20 making 278hp. Under WOT usually a 1-2-3 pull the car wants to go all over the place, sometimes it gets a little unbearable. ive had buddies next to me saying they get scared when we do side by side pulls. i have...

A couple days ago I got the code P0217 and looked into it. It seemed to be an overheating problem, but the car was not actually overheating much unless I was stopped. AC also only worked when I was moving so I narrowed it down to the fans. Here's the thing: both fans do not run by themselves...

Got a 02 rsx type s. Is there a way to pull abs codes with a jumper wire? I looked for a 2 pin plug by the Ecu but didn't find one.

I'm having a problem where when I do a hard turn my steering wheel becomes off center. if I straighten the wheel out, the car will pull to the opposite side. So I'm constantly having to hold my wheel tilted to one side to drive in a straight line. Any ideas what the problem could be? :run:

I just got a used 06 base and the previoud owner appears to have hid an accident from carfax. The cord worked once and I managed to pull it maybe 6 inches out. Is there another way to pop the hood?

http://youtu.be/qF6JHxGxnGk 30-70mph 2nd gear pull Mods: -Reflash #4 -Dc Sports Race Header -Injen CAI -Greddy Evo 2 Exhaust

Im lowered 2.5inches all around and im going to be rolling on 17x9 +12. I know that ill need to roll all four but dont know if i have to pull all four as week does anyone know or have any suggestions? :dontknow: thanks for the help :vtec:

Who knows anybody who can fender roll and pull to fit 18 x 9.5 +15 work 11r with minimal camber. Thanks. I want someone who has done this many times

Whats up guys I'm sorry in advance if this has been asked already, I tried searching but couldn't find anything. So several months ago I got backed into and had to get my passenger side QP replaced. I'm about to buy some wheels but really need the rears out. Is it safe do pull them out despite...

Im having trouble getting my trans out i got all bolts abd mounts out. so i lowered trans and it broke my new drop engineering mount on passenger engine side putting weoght on it. do i need to pull out the starter to get trans out? I cant get top bolt out becuase my suprcharher is in way i cant...

Im dropped pretty low in the back. Need to get my camber to sit at -2.0 in the rears. Dude at firestone told me they were sitting at -3.8 and he couldnt move because they'll rub? Question is has anyone tried this method here before and think its a good idea? Or is there a better method out to...