Acura RSX, ILX and Honda EP3 Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-16 of 17 Results
  1. Problems & Solutions RSX
    Solution: I ended up cutting away any of the firewall insulation where the side cover pressed against. It's easy to see the areas where it was rubbing. I also broke the two plastic guide pins in the heater box that help the cover but it was causing me issues. What I did was make sure none of the...
  2. Problems & Solutions RSX
    How did you guys install the side vacuum hose to the elbow in the picture? The tube right below the green cap
  3. Transmission EP3
    First, sorry to start another thread about the dash, but I am stuck here. Second, I was nuts enough to do this. To replace this. Finally, I have it almost all put back together, but I am stuck with the gear shift mechanism. I was using the Honda Service Manual to remove all of this. Now...
  4. Transmission & Drive Train RSX
    its a 5spd EP3 tranny that i just added the 6th gear to and replaced the 3rd gear set on the mainshaft... assembled both shafts and afixed them into the tranny and the top countershaft bearing rests on the mainshaft's 6th gear (as if the counter shaft is low or mainshaft high by a mm or 2)...
  5. Suspension, Chassis & Brakes
    I currently have the Skunk 2 pro s coilovers which use the stock top hats. I am reinstalling my stock suspension and need to know the order of the bump stops and bump stop plates for the front and rear. I am sure I could figure it out, but would appreciate if someone could tell me in order or If...
  6. Problems & Solutions RSX
    I pulled my rear seats up to do some work and now I am having a hard time getting the tabs to click back in. Picture: That picture is not mine - it's from someone who posted on how to remove the seats here on CRSX. I need Point A to clip back into Point B and it doesn't seem to want to click...
  7. The DIY Garage RSX
    i was wondering would it be ok just to have all the taps and the 2 screws on both sides? Without the 4 screws on the bottom? It saves a lot of time and hassle without those 4 screws when removing the bumper, does anoyone ditch those screws?
  8. Transmission & Drive Train RSX
    ok guys i went to install my shifter mechanism on the trans today and for the life of me i couldnt get it to go in. so i checked out inside the trans and noticed that the shifter fork things were not all lined up... now im not sure if they are suppose to be or what. but i stuck my fingers in...
  9. Suspension, Chassis & Brakes
    How do you keep the bolt from spinning when you tighten the nut?
  10. General RSX Discussion
    I keep track of my mpg every so often, and after going back to stock from a fujita CAI, I recorded 34.33 mpg. I usually get 29-30 mpg with the CAI. Drive 70-75 on highway and a little hard on street.About 75% highway/25% street driving. I do have hondata IMG, but that is all. Thought id share.
  11. Problems & Solutions RSX
    I need to reinstall my stock header/cat so I can register my car in CA. The problem is, I left it outside and it has some dirt inside the pipes from rain splash. I cleaned it out the best i could with simple green and paper towels, but of course there's still some dirt in there. don't give me...
  12. Lighting RSX
    hey guys got in a car accident and ended up with a new bumper but the shop couldn't install the fog lights >< so now i have my old fog lights with my new bumper and no idea on how to install them some pointers please ><
  13. Problems & Solutions RSX
    Well I'm sure many of ya'll have run into the same problem of wearing out the floor mat around the clutch... since Acura has decided no longer to sell the individual part but only the set, I don't think I'll be buying it... I'm probably going to look at a custom mat or maybe even a generic mat...
  14. The DIY Garage RSX
    Parts list: - Bag of bolts, screws, washers - Airbox Step 1. ??? Step 2. Profit!!!! No, seriously. Has someone written a guide on reinstalling the stock box? I'm sure I can do it, but it may take more time than the CAI install because I took it off so fast and it was almost a year ago...
  15. ECU Tuning RSX
    I had an injen sri and took it out to take the car to the dealer but my vtech no longer engages, has anyone else experienced this problem. (I put the airbox in right before you ask)
  16. Turbo RSX
    My friend has a magnaflow exhaust for his eclipse. he says its universal and he wanna sell it to me will it fit my type-s ?? thanks for ur answer!!
1-16 of 17 Results
Top