searching

I bought a 2002 rsx type s with a 08 si transmission already in it and I need to replace my axle I just want to know if a 2002 rsx type s axle would fit or no? Thanks in advance

Hi,looking for buddy club spec 2 exhaust for the dc5?

Hey new to the site, no rsx yet. I'm looking though. The one I almost height today got sold before I could get there. Hoping I can find one I like soon. Figured I'd register and read up before I buy one.

So question that i can't seem to find... Currently have an 05 type S, would an EP3 axle back bolt right on? I seem to be able to only find results which have RSX S header/RH & catbacks being put onto EP3's, but never the other way around. Read that there is about a 3 inch difference between...

Hey guys, ive done my searching before posting and every lead has come to a dead end. Ive seen some good reviews of reps from ebay, but now all are priced at 500+ which is ridiculous for a rep that reviews say were under 200$. If anyone can point me in the right direction of a good fitting...

Not sure how common this setup might be... But if any of you have a basemap similar to a K24a2 with a bolt on greddy turbo kit I would greatly appreciate it.

I've searched everywhere and have not found my answer. The camber kit in question is by wicked tuning, but since all of the rear camber kits for our cars seem to have a universal design any input should help. I bought the kit used and I have been attempting to adjust the rear camber, but the...

Hey guys I'am in the hunt for a decently good shape Arc Oil cap to complete my arc setup in my S2k. Color doesn't matter. Have to be able to ship. Text me for faster response if you have one you would like to get rid of of know someone. Thanks! Rene' 405-three 1 three- 5 six 2 zero

im looking for a greaddy fmic kit. let me know what you have

Hello all, I have run into a stumbling block in my build. I am building a turbo set up off of a sidewinder manifold, and a Precision 6262. The turbo has a 5 bolt discharge, and I am trying to figure out where I might be able to find a 3 inch downpipe for a sidewinder thats 5 bolt. Any help would...

I have a set of enkei's that are 17x8 +38 and a set of 225/45/17s. Also im on BC N+ with like no gap in the back and 1 finger in the front, planning on lowering the front when wheels go on to be even. Question - am I gonna need to roll my fenders and camber? Ive had these on my car before and...

Hey, I spun a rod bearing and have my block at a machine shop to have crank machine and over-sized rod bearings installed but he needs .030"/.75mm rod bearings and he can't find any. His part sources don't carry them. So I'm trying to see if anyone has any suggestions of either online retailers...

I have searched and I know it has been answered before but im trying to find out which differential will fit in my 05 rsx with z1 tranny. I know the 05 stock diff will fit perfect obviously because it is identiical. I also heard that the si lsd would be a direct swap because they carry the same...

In Btw BaseAutoSexMobile for COTM! :fyea:

It was either in C&D or R&T, an article called 'high planes showdown' or something like that... anyway, had a comparison of a few cars inc. the protege MP3, EP3 w/ the hfp kit, srt4 etc... thanks in advance for the link!...

this is one of my 1st post so lets roll with it.. from all the searching im doing it appears that the only way to see any gains on the exhaust side is to do a race header? i have a 03 type s, was so close to buying a cat back unitl i read that its almost pointless unless you have a race header...

Anybody have one lying around? I own a 2004 RSX Type S and living in Arizona! I believe if I spliced my injector wires again I wouldn't have enough left over to connect the injector wires! Need a new harness so my car isn't running so rich! It won't hold an idle and is stalling at every stop I make!

Anybody know of some good sites to check out but I can't do Mugen body kits because they are too expensive for me right now! Headlights, would black dual Halos with conversion kit be better than chrome? I live in Arizona and don't know their laws on lights yet!

I am looking for a picture of the stock rims powdercoated black!! I would like to see how this looks before I invest in it. Total props if you have any.

i been looking around for some gold/bronze rims for my white dc5 :shady: but i just cant find any good one any idea what rimz would look good on this car