Search Results for ‘sits’

I recently bought a 04 rsx type s and the only problem I have with it is that the PLM header sits too slow and sometimes scrapes when I’m cruising. Why is it low? Was it not meant for that car? I’m thinking of getting a skunk2 alpha header and selling my PLM header. But i don’t know how it...

https://www.youtube.com/watch?v=ViuqJCy1MhA You might have to turn your volume up a little, but since I bought the car a few months ago, it will make this noise on startup whenever it has been sitting for a while. The noise will come, then I can turn the car off instantly after, then turn it...

only install for once if anyone wants that $300 OBO FCFS http://www.facebook.com/editalbum.php?aid=185743&add=1#!/album.php?id=661051748&aid=185743 http://www.facebook.com/album.php?id=661051748&aid=185743

i got tein s techs for my 03 type s and the rear sits lower then the front how come the rear is lower shouldnt the front be lower then the back?

When i first got it, bone stock: Somewhere inbetween: How it sits today:

idk how to fix this but my headunit sits too far into the dash and it moves around sometimes when pressing buttons, i cant seem to get it to fit in right :dontknow: and my dash kit can be pushed in further than the outline of the dash as you can see, idk if that is normal either, i got the...

I'm wondering, wich of the two lips sits lower, ITR or A-Spec?

Hi guys, I just recently got my Ohlins PCV coilovers installed in my car (Australian DC5R). I made sure all the pre-measurements on the coilover were consistent and measured correctly before putting them on. However the rear left of my car sits about 1 finger gap higher than the right rear. Is...

Does anyone know if the Greddy lip or INGs front bumper sits lower?? I mean which one has better ground clearance?