Acura RSX, ILX and Honda EP3 Forum banner

specs

  1. Suspension, Chassis & Brakes
    Hello guys, I just recently got an alignment and I was wondering if it's good. I daily drive the car and don't track it. Front:Left camber:-1.6 caster: 2.5 toe: 0 Front:Right camber: -1.6 caster: 3.2 toe: 0 Rear:Left camber: -2.2 toe: 1/16in Rear:Right camber: -2.3 toe:1/16in
  2. The DIY Garage RSX
    I did a leak down test on my K20A3 engine with the following results with 28 PSI of pressure. #1 - 8% (Constant) #2 - 8% to 10% #3 - 8% to 10 % #4 - 10% (Constant) Is this within specs? I think I am going to take the header into the shop to inspected/rebuilt just for good measure.
  3. Wheels & Tires
    Hello all from down under (Australia) New member looking for some insight on a new set of wheels and tires for my 05 DC5 type s (RSX-S) I've found some photos of an rsx I fell in love with, owner goes by the name of Adrian and there are a few vids of his rsx on youtube. This is his set up, I...
  4. Engine Building & Design
    What is the service clearance limits specs when your checking foe flatness of the block and head?
  5. Problems & Solutions EP3
    Anybody know the torque specs for the timing chain cover can't seem to find them anywhere i'm doing a head swap so any other specs helps thanks.
  6. Suspension, Chassis & Brakes
    what alignment specs should I have for a drop of 2 inches, because I can't get the to to zero out, can changing the camber fix the toe? Because right now the tie rod ends are too short
  7. Exterior Mods RSX
    Anyone know the specs on the JDM top1 rear diffuser I'm going to be making one and wanna find out sizes
  8. General RSX Discussion
    Read more about the New Civic Type R Specs, Photos Released at AutoGuide.com.
  9. Florida For Sale: Local Pick-Up
    I originally bought these about 3-4 months ago. They were in good condition just needed some paint love. I sent them out to Sharp Customs in Tampa FL and had them professionally redone. Strip, Blast, Powdercoat and stickers. These were my top 5 wheels to ever own, And after now owning them for...
  10. The DIY Garage RSX
    Got bored, decided to make a simple poster for myself to put in the garage and before I knew it.. :face: #designerhabit So yeah, just leaving it here in case anyone else wants to use it for personal. All information came from DropThatHammer thread...
  11. All Motor RSX
    Hey guys I'm looking for a round about number on hp/tq for my new setup that I have in the works. It's a k24a4 dual exhaust rocker assembly (vtec killer setup) with type s cams, rbc intake, port match throttle body and full type s dc sport exhaust. Also have kpro aem wide band and type s trans...
  12. Bolt-On Basics: RSX (Base)
    I cannot find a manual for the engine torque specs. If someone could tell me where I may find that, I would be greatful. Thanks
  13. Problems & Solutions RSX
    Hey everyone, I recently bought a 2003 rsx type s, and it had the power steering pump mounting bolts snap off and left pump hanging and remaining part of bolts inside tensioner assembly where they mount. I'm going to tap and easy out the piece and replace the bolts. But I need to know the specs...
  14. Wheels & Tires
    Just looking for some more info on this setup. It looks fantastic! Better yet it's functional. Just perfect.
  15. Wheels & Tires
    Hey guys :) finally decided to buy some new wheels for my 2003 DC5 and the ones I want are only available in 18 x 8.5, 5x100/5x114.3, +44 offset. I've asked a couple of tyre shops as well as the shop that sells the wheels what size tyres would be ideal and have been told 235/40/18 by the wheel...
  16. Wheels & Tires RSX
    Looking to sell my work vsxx or trade for a supercharger or turbo kit. Specs: F-17x9 +25 (3 inch lip) on 205.40.17- good tires R- 17x9.5 +25 (4 inch lip) on 215.40.17- good tires 5x114.3, Has work japan stickers, work hardware, and comes with center caps. located in south florida...
  17. Wheels & Tires RSX
    17x9 et25 all around . Slight curb rash from accident . Nothing serious if interested contact me and we can talk from there. they are white inside and polished 3 inch lip .
  18. Wheels & Tires
    Just got my wheels in and am looking for what camber specs to run for when i get an alignment. I dont want to go thru Trial and Error . I want to use visual pics for reference so I can get a better idea. I have searched this thread but it dosent include pics. It only includes what u can run. I...
  19. Wheels & Tires RSX
    Have 4 z2 star specs. Plenty of tread left. 5-6/32nds 450.00 PLus shipping. tires by Jordan Dc5, on Flickr
  20. Wheels & Tires
    I got my first DC5 last week and it came with works wheels cr kai or so I have researched and seen pics. Now I don't know what specs such as offset etc. Any place on the rims where I could look? I only know that they are 17's previous owner didn't know either lol Also if someone could tell me...
Top