Search Results for ‘uneven’

2005 Type-S with 180,000 miles. Hondata Race Header reflash for race headers and CAI. I just replaced the spark plugs, adjusted the valve lash, and replaced the air filter. I was having some issues with uneven acceleration before, and it was somewhat better after. Recently I got a code for...

Just replaced all 4 rotors and pads, the rear passenger wears unevenly, pad only touched outside half of rotor and not inside, is my caliper bad...? The wear on the other 3 is f

Hey people...first off thanks for reading. Pretty straightforward symptoms, my front right and back left wheels are doing almost all of my braking. They went down to the steel while the other two wheels still had 3/8” of pad on them. Also, i couldn’t get the calipers on those two wheels to go...

TL;DR? Skip straight to the bolded questions and see if you can answer at least 1 of them... So, I've finally cracked open my clutch and have ended up with way more questions than I originally had. (Here's a link to the original thread for anyone that cares:)...

changed tie rod end, right axel, tire pressures good, alignment is a bit off but that doesn't affect the steering pulling jerk motion towards the right. I do know the lower control arm ball joint is ripped very slightly. But there's no play when I jack up the car and go left-right, or up-down...

My hid fogs (3k 35w) seem to be giving off uneven light, the driver side is brighter and more yellow than the passenger and it also warms up alot faster (5 seconds) where the passenger is still be warming up after 30 seconds, even after leaving them on for awhile the driver side is still...

I recently switched tires, installed my winters and I noticed one of my summer tire is bald on the inside. It's the one on the rear right side of the car. Got an alignment check, toe is within spec, camber is at -3.2 deg both sides on the rear. I got an alignment with the winter tires on last...

Recently decided to go lower on my car so I maxxed out the front of my Progress coilovers and now my car is uneven. Passenger side is about 1 inch lower than the driver side and I have no idea why. Even when I had Mugen SS Coilover (Non adjustable) my car had an uneven car height but wasn't as...

I have recently noticed that my passenger and drivers side tie rod threads are not even once the wheels are set straight, even after an alignment it is not. My passenger side has about 6 or more threads showing while the drivers side has about 2-3. Now I'm afraid that when I increase my negative...

Hey guys, so I have a little tiny problem. Just a little background, I've had some Buddy Club N+ coilovers with all its original springs for over 40k miles. Ride height was set evenly without any problems. Recently, I replaced the front two springs with Swift Springs, keeping the same spring...

I'm experiencing uneven tread wear on all 4 tires. The inner and outer sides of the tire seem to be wearing a lot faster than the middle. I am running on a 05-06 type s Rims and stock suspension. Tires are Michelin Pilot Sport A/S Plus. Tires have been used approximately 20,000 miles. Anyone...

Couldn't find a thread for this...Looking for a fix. I just changed my brakes and realized my tires are ridiculously uneven as far as wear. They have pretty much all the tread on the outside, but the inside is bald, and the middle is almost down to the cords on both front tires. This seems like...

I recently installed some skunk2 springs on my EP about 2 days ago. I noticed today that the left side is a bit higher than the right side of the car. What can this be, does the spring need to settle, should I be worried about bad installation? Thanx for the input...

So my all sides are pretty much the way I want em.. well right -rear is lower than the rest and and the left front is higher than the rest. Can't seem to get the left front any lower even though the right front is lower the left.

I've had this car now for about 5 months and this is my first post here. I've tried to search around for this answer but I couldn't tell if my question was answered. i found one that said something about the piston not turned correctly..? So, I have just replaced the pads and rotors on all...

might be a noob question but going to ask anyways. my car does not sit even (driver side lower then the passenger side) im guessing do to drive weight always being there. can i switch the springs (move left springs to right side of car and move right springs to left side of car)? so it would be...

I just replaced my brake pads and resurfaced the rotors at a local shop, but I noticed that only the inner part (when looking at the front surface) of the rotor is getting worn. The shop replaced the pads to different ones, but it still did nothing. They told me that it could be bad calipers...

So i just checked all my brake pads and i noticed im getting even pad wear on each pad but my driver front, and passenger rear pads are definitely wearing out faster then my pass. front and driver rear??????? any ideas.......

So I got some megan coilovers. Installed em and set every coilover as low as they go. Every corner of my car is uneven. back right has about 1 finger cap. Front right has 1.5 - 2 finger gap. Front left is about 3 finger gap, and back left is 2 finger gap. How do I fix this? Do I really...

So I recently just got some megan coilovers and installed them myself. I made them as low as they can go on front and rear. Before taking to the alignment shop, the car had about a 2 finger gap all around. After getting it aligned, I have noticed that the front left has a little under a 3...