Acura RSX, ILX and Honda EP3 Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-19 of 114 Results
  1. Problems & Solutions RSX
    I need to tap into a vacuum line for a muffler that acts as an exhaust cutout. I keep seeing people tap into the u shaped tube by the intake, and the brake vacuum line but everyone is saying it’s a bad idea to tap into them. Is it fine to tap into the u shaped one ? If not is there a better line...
  2. Problems & Solutions RSX
    In pulling off the small 8mm hose with my pliers, I managed to crack the vacuum T-fitting. I can't seem to find what part this is, any leads? Broken Intake Fitting I've gotten close to what I need on Acura Parts Warehouse, but hit a dead end. At the below link, I need what's just beyond part...
  3. Engine & Transmission RSX
    SOLD
  4. Problems & Solutions RSX
    Was installing cold air intake yesterday. I ordered the secondary hose from INJEN and they sent me some tiny ass vacuum hose that was way to small. So I went and bought some hose that was obviously a little to small but still fit. When I was putting he hose on it took a little bit of force , and...
  5. Problems & Solutions RSX
    02 RSX Type S 164k Engine is stock except for AEM intake and Invidia exhaust Did autocross this past Sunday. All was well until the rain came... started pouring so hard they ended up cancelling at the end. So I'm on my last run, splashing through the course. I finish, and immediately notice I...
  6. Bolt-On Basics: RSX Type-S
    Ok, so here is the deal. I have a Skunk2 Pro-series manifold. everything worked fine I thought. But the port up by the block (the one you can block off) is barely pulling any vacuum when the car idles, I dont hear a whistle sound when its open to atmo and when I put my finger on it theres not...
  7. Problems & Solutions RSX
    2004 rsx s wont idle below 2300 even when warm. There is no check engine light while the engine is running. When the key is on, the cel stays on for a few seconds, flashes a few times, then turns off. Just replaced the intake and throttle body gaskets, as well as the timing chain and chain...
  8. Problems & Solutions RSX
    Stock, base '06 MT I was wondering if I might have a leak in the evap system.. I don't feel or hear any vacuum when i open the gas cap to refuel. Gas cap is fine. I tried opening the gas cap when idling and the rpms seem to drop off to 400 rpms, stutters then shoots up to 900 then to 700 and...
  9. Problems & Solutions RSX
    okay i have an 02 rsx type s and has a CEL code of P0505, when engine is cold in the morning and i start it RPM is aroound 1800 - 2000 and slowly goes down to 1300-1000 i think thats normal since engine is cold but when i drive it and i start slowing down or going to stop it fluctuate, the RMP...
  10. Supercharging RSX
    I'll try to keep this as short as possible. 2005 rsx type s with a Comptech supercharger and a 3.15 pulley. Makes 5-6 psi. I live in Sierra vista AZ which has an elevation of around 4,600ft. I purchased it as is from a place in New Mexico with an elevation of 3,900ft. The car has ran great...
  11. Supercharger EP3
    So I want to know what is up with the vacuum lines on my SC and TB. That L bracket covers up the port where the MAP sensor usually goes. From other pictures I've seen, the map sensor sits on an adapter that has another port on it that goes to the manifold. Mine is just rigged straight to the...
  12. Problems & Solutions EP3
    Hello all, I just bought an EP3 2002, the previous owner told me that it has a K20z3 from a 2008 Civic Si, but I'm not sure, looks like a K20a3 to me, how can I know the difference, because the intake manifold looks like the one of the K20a2 (Rsx-s). The price was fair, so I'm really just...
  13. The DIY Garage RSX
    Where does this Vacuum line go to?
  14. ECU Tuning RSX
    Hey guys, Need some help on a idle problem that started out of no where, my car has been sputtering lately during cold starts and idle (kinda of sounds like a missfire), so i asked my tuner to see if he can take a look what could be wrong with it and he said I'm getting insufficient amount of...
  15. Problems & Solutions EP3
    Trying to troubleshoot a misfire cyl 1 and 2 using live data, can anyone give me the vacuum reading at idle, stock 2002. I'm only getting 9inHG.
  16. General RSX Discussion
    Hey guys I looked and didn't come up with anything so I gotta try here.. just looking at my 06 type s I noticed that today there is a sharp looking broken fitting for a vacuum line on the fuel pressure regulator? ( at least that's what it looks like). Can anyone else confirm if there is a line...
  17. Forced Induction & Nitrous RSX
    Hey everyone!! Got a Silver (New Gen) Vibrant Vacuum Block BNIB Price: 50 shipped obo Text me at 80482455sixzero Heres a pic!! LMK!!!!!!!!!
  18. Problems & Solutions RSX
    Hey everyone, I started a thread in the ALL MOTOR section that should probably be here. Please see my most recent post, #6 regarding valve lash for aftermarket camshafts. Thanks http://forums.clubrsx.com/showthread.php?p=40771522&posted=1#post40771522
  19. All Motor RSX
    I just installed stage one cams and RDX injectors. I am also getting my car internet tuned by Mag Tuning. He noticed that my MAP sensor is reading low at idle, -12 inHg. He said normal should be between -18 and -20 inHg. He believes I have a vacuum leak. The only part of this install that...
1-19 of 114 Results
Top