Hey guys I am trying to remove and replace my SRS module and I can’t seem to figure out how to remove the two yellow 18P connectors from my old module ito get it out and I don’t want to break them. What’s the trick? Thanks, Pat
1) I want to buy PIAA Ion Yellow fog bulbs and a Spyder/Spec-D kit.
The question is - do I need to buy yellow kit and install the yellow bulb in to it, or do I need to buy a white/clear kit and install the yellow bulb in there?
Will my yellow bulb be brighter in a white...
I'm going forward with my 05 front need conversion so I don't need these things anymore. Bought the headlights from a member on here. They were pretty much new. I haven't even installed them on my car to be honest. I think they're Delos. Not sure tbh but they look really nice. I also have some...
I can successfully reset the SRS light with paper clip method, as long as I have the seat belt inserted into belt buckle. As long as I buckle up before starting the car, the light stays off, but if I unbuckle while car is on, SRS comes on instantly.
This leads me to believe that replacing the...
looking for realible H11 bulbs, that will last a decent amount of time
im thinking of these but not sure.
So i have a k20a and took of my rbc intake manifold and saw this yellow sticky gunk in my intake runners, and inside my engive intake valves? Anyone can shed light what is causing this? Should this be a concern of engine failure if this issue continues?
Hey guys, quick question (kinda not really clickbait) lol
My plan is to install a pre-amp in place of the headunit, since I'm working on my Nexus 7 Dash kit. Click here if you'd like to see.
As seen below, I'm using the good ole Metra harness. Speaker wires are ezpz, Remote will be bypassed...
02-04 OEM headlights. housings painted to match the type r JDM style headlights. so it's a very dark bronze, you can only see the bronze when the sun hits them. high beam housings have been painted anodized yellow. lenses are perfectly clear no hazing whatsoever. all OEM parts. no broken tabs...
Got some extra parts for for sale just taking up space in my garage located in San Diego, ca or can also ship anywhere in the US!
(2) 30mm spacers 5x114.3 / 64.1 hubcentri- $60 shipped
-OEM window side moldings - $40
-05-06 OEM rear taillight bracket passenger $25 shipped
Headlight rear seals...
Looking for a set of koni yellows for rsx 05-06, must be able to ship to Toronto or be located near Toronto . Also willing to look at a full out coilover setup, looking at mugen SS, aspec, or whatever give me your offers. Thanks
Searched to see if anyone else had this problem and cannot find anything.
i cut around the circumerence of my oem strut, 40 mm from the top of my strut housing for the front strut. I drilled the hole in the bottom, and now the koni insert doesn't seem to want to go in anymore.
I've searched the forums and it seems hard to find an answer to my question.
I'd like to keep the stock springs and replace the oem struts with koni yellows since my oem ones are blown.
I can still run stock class in autocross with aftermarket dampers and oem springs, but I was wondering...
I was taking out my quick release to go back to the OEM wheel and I saw this plug in the steering column. I have no idea where this should plug into or what it even does. I would really appreciate it if anyone could tell me what this is and where I can plug it to or if I should just leave it...