[Them Witches]

The 1st part of doing some small changes to the bar adding pipe into the channel of brace. The bushings slide more on the painted surface and grip better with carbon fiber 3mm plate washers. The bar looks better without the Progress logo.

I got to go weld this up and do an install to see if there is anything else I want to do to the bar or can

 

[BrutalB83]

But I like the Progress logo!

Cool project, though. The carbon plates are awesome.

 

[Them Witches]

The brace had one bad hole line up and I was not able to get the bracket to bolt up on one bushing. I will have to take it back down and bore it out. I also cut holes so the brace would not drag air

 

[Them Witches]

But I like the Progress logo!

Cool project, though. The carbon plates are awesome.

Thanks brother

 

[BrutalB83]

Thanks brother

The holes are a nice idea! I see why the Progress logo had to go.

 

[Them Witches]

The holes are a nice idea! I see why the Progress logo had to go.

you see how the brace drags air by the photo I took.

I have to take the kit back down right now and try to adjust the one hole on the bushing bracket, either the brace has an alignment issue on a hole or my carbon fiber plate is causing the issue. I swear...

 

[Them Witches]

@BrutalB83 I think I should do a carbon panel on the subframe like this..

 

[BrutalB83]

That would be awesome!