Acura RSX, ILX and Honda EP3 Forum banner
1 - 1 of 1 Posts

2,958 Posts
compdoc777 said:
So on Kpro I need to set the readiness when I drive in or before?
This may or may not work depending on the equipment your testing place uses.

Most equipment will run an OBDII test. From my understanding, it basically sets the readiness itself and then runs through all the codes to make sure they work properly. Anyway, if you would throw a code after 300 miles, you would throw the same code after the check.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.