Your camber can also affect the finger gap measurement. Cuz the more neg camber you have the more fingers you can fit in the gap. I don't know if that makes sense its hard to explain.
coilover install problem, one side sits higher than the other??
Hi guys,
I just recently got my Ohlins PCV coilovers installed in my car (Australian DC5R). I made sure all the pre-measurements on the coilover were consistent and measured correctly before putting them on. However the rear left of my car sits about 1 finger gap higher than the right rear. Is there a problem I should be concerned with, or should I wait for it to settle and get it corner balanced/aligned. Any suggestions/opinions will be much appreciated!
I just recently got my Ohlins PCV coilovers installed in my car (Australian DC5R). I made sure all the pre-measurements on the coilover were consistent and measured correctly before putting them on. However the rear left of my car sits about 1 finger gap higher than the right rear. Is there a problem I should be concerned with, or should I wait for it to settle and get it corner balanced/aligned. Any suggestions/opinions will be much appreciated!
1 - 1 of 22 Posts
1 - 1 of 22 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Acura RSX, ILX and Honda EP3 Forum
A forum community dedicated to Acura RSX, ILX and Honda EP3 owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, K24 swaps, turbo kits, and more!
Full Forum Listing
Explore Our Forums
