Acura RSX, ILX and Honda EP3 Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
typespilot
Joined
·
449 Posts
Discussion Starter #1 (Edited)
For sale is my DC5 Type R front lower arms with an extra set of front compliance bushings from a DC5 Type R vehicle.

SOLD!


The bushings are specific to the type R because they have aluminum casings instead of steel like the USDM version.

The DC5 Type R front lower arms are in good shape and I personally cleaned them up prior to listing them. They are significantly lighter compared to the USDM version.

These arms change the suspension geometry slightly and require a JDM front sway bar specifically designed for the DC5 type R.

The bushings are in very good shape as evidence by the photos.

Item listing on eBay: http://www.ebay.com/itm/DC5-Type-R-front-lower-control-arms-/182591281715?hash=item2a8349da33:g:WrQAAOSwIQdZJmU5&vxp=mtr



IMG_9214 by Corey Ganoom, on Flickr

IMG_9216 by Corey Ganoom, on Flickr

IMG_9230 by Corey Ganoom, on Flickr

DC5 Type R aluminum front lower arm by Corey Ganoom, on Flickr

DC5 Type R aluminum front lower arm by Corey Ganoom, on Flickr

DC5 Type R aluminum front lower arm by Corey Ganoom, on Flickr

DC5 Type R aluminum front lower arm by Corey Ganoom, on Flickr

DC5 Type R aluminum front lower arm by Corey Ganoom, on Flickr

DC5 Type R aluminum front lower arm by Corey Ganoom, on Flickr

DC5 Type R aluminum front lower arm by Corey Ganoom, on Flickr
 

·
Registered
Joined
·
620 Posts
Is the Type R Front Sway bar the only requisite to install these LCAs on the USDM RSX or is something else required as well?
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top