Acura RSX, ILX and Honda EP3 Forum banner

DC5R Cant select reverse whilst motor running.

418 views 1 reply 2 participants last post by  DOHCtor 
#1 · (Edited)
Apparently the speed sensor is telling the "solenoid that stops selection of reverse above 30mph" that its doing above 30mph all of the time.
If I turn the motor off I can then select reverse.
If I disconnect this solenoids plug(with the motor running) I can hear the solenoid droping out and I can then select reverse.
There is voltage at this plug all of the time that the motor is running but
I am sure that this shouldnt be the case.

I assume its a speed sensor giving this solenoid its signal but I disconnected the speed sensor (the rear most one on the gearbox I believe) but the problem is still there.


Suggestions anyone?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top