[SanDiegoLoCo]

When I put the car back on the ground the sway bar is resting on the control arm and it is actually fuqn up the control arm... did I put it in upside down or something


Sent from my iPhone using Tapatalk

 

[SanDiegoLoCo]

I didn’t install spacers in the sway bar links but I didn’t think I was low enough for it to matter? -_- any advice would be dope I got the 24mm progress rear sway bar with bwr control arms


Sent from my iPhone using Tapatalk

 

[mfarmakas17]

Looks upside down to me bro. The ends should arch over the LCA rather than towards it.

Here's a pic of mine for reference. This is the ITR sway, but you can see the arch I'm talking about.

 

[SanDiegoLoCo]

That’s kind of what I thought -_- LoL


Sent from my iPhone using Tapatalk

 

[SanDiegoLoCo]

Hard to see but I flipped the bar and the clearance was fine, red to adjust it one more time it’s touching the exhaust but I think I can get it a lil more clearance by adjusting the bracket


Sent from my iPhone using Tapatalk

 

[mfarmakas17]

You can try shortening or bending the hangers to tuck it in a bit.

Torque Solutions sells a set of exhaust insulators in PU for our cars. Might be worth a try considering it's only $30

 

[InTheZone]

You can try shortening or bending the hangers to tuck it in a bit.

Torque Solutions sells a set of exhaust insulators in PU for our cars. Might be worth a try considering it's only $30

no, it's upside down as someone else mentioned

 

[SanDiegoLoCo]

no, it's upside down as someone else mentioned

Yeah I flipped it around after the first pic, the last pic I posted was of it after I flipped it, still have slight clearance issues but I believe I can adjust the bar down slightly with the bracket to give me a mm or 2mm more of clearance, will repost tomorrow after I adjust again


Sent from my iPhone using Tapatalk