Acura RSX, ILX and Honda EP3 Forum banner
1 - 2 of 2 Posts

291 Posts
Discussion Starter · #1 ·
Hey everyone

I was in an accident about a month ago and my driver's side headlight needed to be replaced.

After getting it back from the shop, the beam pattern on the replaced driver's side light is all blotchy when I shoot my headlights on the wall and shooting up pretty high. The passenger side is normal and has definitive straight edge cutoffs.

The bulb looks like it's seated just a MINISCULE off pointing slightly down when I look into the housing from the inside. Could this be the source of why the beam pattern is blotchy?

The replaced headlight is also quite a bit brighter: could this be because of the aiming or because it's a new bulb?

Any help appreciated. Thanks.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.