Acura RSX, ILX and Honda EP3 Forum banner

1 - 4 of 4 Posts

·
NvUS East Coast
Joined
·
185 Posts
Discussion Starter #1
Hello,

I am attempting to install my 4 Port Hondata Boost Controller per Palmer's DIY but the B21 pcs wire does not exist on my Wireworx engine harness. Should I just add a pin to my B plug and run my boost controller wire to it? Any other options? I've searched high and low for an answer to this. Has anyone else experienced this?

Thanks!
 

·
NvUS East Coast
Joined
·
185 Posts
Discussion Starter #3
Hey Joe,

Yeah I actually did figure this out. I ended up pulling a pin w/ a bit of wire from my stock harness and adding it into the plug then soldered the boost controller wire to that.
 
1 - 4 of 4 Posts
Top