Acura RSX, ILX and Honda EP3 Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
To preface this, I have an ‘06 Base RSX and just bought the Duraflex Seibon Fiberglass Vented Hood. The car has been in 2 front end accidents before installing the new hood. I am unsure how to adjust the hood’s body lines (since I’m relatively new to aftermarket exterior parts). Any advice?
I have already tried the rubber bump stops on either side of the car, and I’ve considered the possibility of a bad hood latch. I just wanted to make sure I was looking in the right spots before doing anything else.
Thanks in advance, guys!
-Jeff
564682
564683
 
1 - 1 of 1 Posts
Top