Acura RSX, ILX and Honda EP3 Forum banner
1 - 20 of 30 Posts

·
Stealth is more fun
Joined
·
594 Posts
Discussion Starter · #1 · (Edited)
Ok, I have too many parts laying around. Here are some things I'm willing or need to sell:

1) Image Dynamics IDQ 12" V2 dual 2 ohm voice coil subs, NEW (never mounted), two of them.

2) *RARE* Illusion Audio ND-12, single 4 ohm coil, two maybe more available. Very light (8lbs), thin & high quality, but expensive.

3) Aura Pro bass shakers, 2 of them. I have the (custom) mounting accessories to install them under the front seats of a 2005 RSX-S, I imagine other years have identical fitment. If you don't want to run subs but want to feel the bass, I highly recommend these. Very cool effect. 3 lbs each, and they take up no usable space.

4) 1 farad Monster Cable caps, NEW. I have at least 4 of them still sealed in their packaging.

5) Pioneer FM modulated XM radio setup. Works with any FM radio.

6) Old Aura Mobile Reference amplifier, 50 x 4 RMS minimum. Doesn't work, probably simple problem; I bought to play around with, but I hardly have time to do the daily chores, much less play.

7) Speaker wire, RCA's, other misc wire and parts used for installs.

8) RSX Dash kit (new).

That's all that comes to mind at the moment. Please make offers, if it's good enough, it's yours.
 

·
Registered
Joined
·
8,340 Posts
wat brand Speaker wire, RCA's, other misc wire and parts used for installs?
 

·
Stealth is more fun
Joined
·
594 Posts
Discussion Starter · #6 ·
how much do you want for both idq's shipped to milipitas, ca?
I can do $300 shipped on the pair. I have a 3rd (used) that I could probably be persuaded to sell. I love the IDQ's, but I'm going to use lightweight subs in the RSX (Illusion Audio), and I already have a bunch of IDQ 15's for my house.
 

·
Stealth is more fun
Joined
·
594 Posts
Discussion Starter · #7 ·
wat brand Speaker wire, RCA's, other misc wire and parts used for installs?

The speaker wire is about 50' of 12-2awg twister pair with translucent insulation; the wire is tinned such that it doesn't oxidize. American Bass AB-300. See the following post for a picture.

The RCA's are mostly Esoteric (Streetwires) and a few Monster Cables, I'm not even sure what else I have laying around any more. I'll have to make a list when I clean up in May. I used to do installs on the side (including for myself), so I have a bunch of misc. parts I'm not going to bother to list. I'm not interested in selling only one or two small parts at a time just because of the hassle, but if you need other significant parts then I can do some digging.
 

·
Stealth is more fun
Joined
·
594 Posts
Discussion Starter · #12 ·
4 ohms each. I would prefer to sell this to someone who wants to use in an RSX, because I had to custom make some of the mounting pieces, and I had to cut some of the heatsink to fit properly. Not that it affects operation, but it would look out of place if it were visible. Either way, I'd like to get $80 shipped for the pair since they were hardly used (I ended up just putting subs in my car, so didnt' really need them). The shakers definitely make you think the bass is unreasonably strong for a pair of 6.5" mids! It's a cool feeling, and I'll be content to save these for my home theater if they don't sell.
 

·
Registered
Joined
·
8,340 Posts
how much shipped for a monster cap? Pm me
 

·
Stealth is more fun
Joined
·
594 Posts
Discussion Starter · #20 ·
I'm expecting to get over $200 each for them on eBay when I finally get around to listing them. I'd rather sell them to someone who will take advantage of how light they are, or will use them in a nice SQ setup. They really are the cleanest subs I've ever heard, to the point where the ND-15 was more accurate than the 12" subs I compared it against. I really wish I could find some ND-15's again, but I'll still be happy using some of the ND-12's I have.
 
1 - 20 of 30 Posts
Top