Acura RSX, ILX and Honda EP3 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
724 Posts
Discussion Starter #1
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=33695&item=2460933167

This is the link to the pedal set I was thinking about getting. The only question I have is how hard would the install be? I saw a post on how to just change the pedal covers and it seemed somewhat difficult ie. drilling out screws and such. I think this MIGHT be easier , it looks like maybe all you would need is some wrenchs and a screwdriver. If anybody has any specific knowledge in this area please share :)
 

·
...
Joined
·
64 Posts
The control arms for the pedals do not fit the RSX. You will have to drill out the rivets in the pedal covers. (see below)
The "Dead Pedal" is a direct swap.
The "Brake and Clutch" covers replace the stock rubber covers.
The stock gas pedal needs to be shaved down a little to accept the JDM gas pedal cover.

The whole job takes around a half an hour to do with the correct tools.
 

Attachments

·
one.4our.3hree
Joined
·
9,128 Posts
looks like ur better off with mugen pedals
 
1 - 4 of 4 Posts
Top