k20a2 starter for 02 rsx type s with k24/k20 frankenstein
Join the discussion
Recommended Reading
-
Bogging after DC race header install
Bolt-On Basics: RSX Type-SWassup yall! I just installed the DC race headers on my 06 type s and now its bogging when I accelerate on all gears pretty much. Seems like the bogging happens only for about 1-3 seconds and it will go away afterwards and the car will pull hard. On the install, I used old gasket and no gaskets...- 6
- 374
-
Diegodawwg · updated
-
Used KTuned Race header normal oxidation?
Bolt-On Basics: RSX Type-SI bought a K-Tuned RaceHeader from eBay in 2016 and put about 15K miles on it. More specifically I bought the more expensive $600 stainless steel version KRH-RSX-K20 and not the $300 budget one. Currently, I have another race header installed and I am trying to sell the KTuned one. I ended up...- 2
- 1K
-
Shorty15c4 · updated
-
K tuned header leak sounds horrible
Bolt-On Basics: RSX Type-Shey so i just installed k tuned header on my 06 type s i bolted it up temporarily with my stock exhaust and it sounds like pure garbage sounds like i just have a serious exhaust leak even though there isn't one it was installed professionally and i inspected it as well apparently the header its...- 3
- 2K
-
N/A Dyno Graphs
Bolt-On Basics: RSX Type-SPlease do not post on this forum unless you are posting a dyno graph with a list of mods. If you have any questions, please PM the thread creator or contact the forum Moderator. Thank you.- 1K
- 297K
-
doreamon_snatch · updated
-
Ported RBC/Throttle Body
Bolt-On Basics: RSX Type-Shello I picked up a ported RBC (70mm). would I need to either pick up a aftermarket 70mm throttle body or have my type s stock TB bored to 70mm and run an adapter? looking for the best option! thanks! 2004 rsx type s- 4
- 407
-
PhoDuhNguyen · updated
Join now to ask and comment!