Acura RSX, ILX and Honda EP3 Forum banner

kpro nitrous control

538 views 2 replies 3 participants last post by  Ravelin00 
#1 ·
what is a good starting point for these inputs in red


Conditions
Minimum maximum
Engine load ?85? ?160? kPa

Throttle ?85? ?110? %

isnt about 89 kPa full engine load? so it seems as if these two parameters, engine load and throttle% would almost always be equal with each other. how is it that you could have pretty much full throttle but have less than max engine load?
I just need to know how to set this portion without hurting the engine.thanks
i was reading the help book on kpro but need clarification on this part
 
#2 · (Edited)
N/A...hmm

I'd say 95-110% for the TPS and -1 to 1 psi for engine load.
I know that when I removed my blower for maintenance reasons,
my max reading on the MAP sensor was like 0.1 psi. Hopefully someone
else can give input. An N/A datalog would prove to be very useful in a
case like this so you can actually see how much load the engine is under.
 
#3 ·
well full throttle is 100% but i think it reads as 102%, why i dont know but i set mine to activate between 100 and 102 to make absoultly sure its wide open. as for the engine load im not sure ill have to check when i get home
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top