Manual conversion

1 - 1 of 1 Posts

Ricardo5cd

Registered

Joined 11 months ago

4 Posts

Discussion Starter • #1 • 4 months ago

Hey guys ...I’m doing a conversion on my base by installing a 5 speed box that came out of an ep3 however I’m being told that it’s MUST that I change my ECU ... it’s there any truth to this ? Or is there a way around it ....

1 - 1 of 1 Posts

Join the discussion

Recommended Reading

DIY: Mainshaft Thrust Adjustment

Transmission & Drive Train RSX

Mainshaft thrust adjustment I thought I'd make a little DIY to clarify some of the steps outlined in the helms manual for checking and setting the mainshaft thrust on a 6 speed k-series transmission. DISCLAIMER Use this guide at your own risk. I assume no liability for anything that happens...
- 27
- 22K
- BigWorm85 · updated 13 days ago
civic si lsd fit in rsx?

Transmission & Drive Train RSX

hey sorry if this was already asked but i couldnt find anything on it... will a new civic si lsd fit in my 03 rsx-s i have the oppertunity to get it very cheap if it will work
- 15
- 3K
- R
  Ravelin00 · updated 20 days ago
K20 case on k24 transmission

Transmission & Drive Train RSX

Ok so I have a base 05 with a blown trans, I found a cheap accord 5 speed near me. I know the trans mount is different, could I just swap a k20 case on it? If not what mount would I have to use for it to work in the rsx? Thank you very much.
- 0
- 161
- S
  SlowBoi · updated 1 month ago
17mm Bolt size question

Transmission & Drive Train RSX

Hello, I just replaced my clutch/flywheel. There was a 17mm bolt that I believe went through the starter motor that I stripped pretty bad. I was able to remove the bolt, but I want to replace it with a new one. I have searched through many part lists, I am having trouble locating this bolt. I...
- 1
- 525
- S
  sammyz · updated 3 months ago
Replaced clutch now car won’t start

Transmission & Drive Train RSX

I replaced my my clutch now my car won’t start any ideas? I went back through and checked all wires of damage and made sure they were connected and clean as well as the ground on the bell housing. I tested spark after new plugs and it was good but the car didn’t wanna start. It was trying to...
- 2
- 483
- K
  Kino562 · updated 3 months ago