Motor mounts or inserts?

10567 Views 40 Replies 8 Participants Last post by adotwu86, Dec 28, 2017

jRSX19

Discussion Starter · Nov 10, 2017

So I'm pretty much on the verge of putting a header on my car. I know I need to have motor mounts, but can I just put inserts in the mean while? They're way cheaper then mounts and I'll only have them on for about a month or two at most while I get the mounts. Good idea or bad? Any particular brand in mind for insert?

Sent from my iPhone using Tapatalk

Save

1 - 1 of 41 Posts

Thewrai6th

· #7 · Nov 15, 2017

DC5Sandbag said:
Energy Suspension

^ Ran these inserts on my DC2 turbo with new OEM mounts. Night and day difference on launches, wheel hop was 90% gone. No more busted axles.

A Koni/GC suspension setup removed all remaining wheel hop.

I had replaced the OEM rear mount with a poly mount, but had to remove it because I couldn't stand the dash vibrating in my DD.

Save

1 - 1 of 41 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month