Acura RSX, ILX and Honda EP3 Forum banner
61 - 80 of 100 Posts

·
RealTalk
Joined
·
5,636 Posts
Yupp make a thread over there you'll have a warm welcome waiting.for ya
 

·
Unpopular Opinion
Joined
·
458,195 Posts
Wow, wasn't excepting such an amazing build inside this thread! Sub'd :shady:
 

·
06 TypeS
Joined
·
2,551 Posts
Discussion Starter · #65 ·

·
Red Rider!
Joined
·
360 Posts
Lookin good bro. Quite the respectable project you got goin on here. paying attention to detail is somethin everyone should be doing, but not that many actually are doing.... I can say I'm slightly jealous, even though I dont want to boost my car....

Keep it up, would like to see the progress....
 

·
RealTalk
Joined
·
5,636 Posts
Wow dat IM looks sick man, nice work.

Engine bay is looking more like it.
 

·
Unpopular Opinion
Joined
·
458,195 Posts
Damn that mani is fit! I love the low key color. Not taking to much attention away but still one to note as eye pleasing in the bay. What did you use on it paint? Is it just drying in the oven? or is it cause you powdercoated it?
 

·
06 TypeS
Joined
·
2,551 Posts
Discussion Starter · #70 ·
Wow dat IM looks sick man, nice work.

Engine bay is looking more like it.
thanks man! Much appreciated!

Damn that mani is fit! I love the low key color. Not taking to much attention away but still one to note as eye pleasing in the bay. What did you use on it paint? Is it just drying in the oven? or is it cause you powdercoated it?
Yea I didn't actually like the color at first and was going for more of a silver than a dull grayish color but after having it on there and looking at it together I'm starting to like it.

Yea it's powder coated. So I am stuck with it until I sell it. Pretty sure it wouldn't be easy to strip lol..

Thanks for the comments guys! More motivation for tomorrow!
 

·
06 TypeS
Joined
·
2,551 Posts
Discussion Starter · #76 ·
Well this is how my shifter will be sitting...so everyone can see her beauty..





Now... who has installed an efr turbo or turbo that is water cooled.?.

Where are the coolant lines suppose to be routed to?




Also why did my kit not come with the return plate that mounts to the turbo? I have the 3/8 to 10an but not the plate that mounts to it..

 

·
06 TypeS
Joined
·
2,551 Posts
Discussion Starter · #78 ·
looks like the return works w/o the plate too
Almost.. that's what I was thinking too until I tried to install it. Hits on the cold side after 1 turn and can't remove anything to make it clear.. lol. Not sure how fullrace was intending on hooking this up.

For the money they should really send some instructions for it..
 

·
RealTalk
Joined
·
5,636 Posts
But u installing the fitting on its own, not with the other end.

The plate would make better sense
 

·
RealTalk
Joined
·
5,636 Posts
As for the cold side the clamp holds it in place. Just loosen n remove it
 
61 - 80 of 100 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top