Acura RSX, ILX and Honda EP3 Forum banner
1 - 1 of 1 Posts

·
I am evil homer!
Joined
·
148 Posts
Discussion Starter · #1 ·
I purchased a spoiler from spoilerdepot.com (looks like a wings west replica) and the holes in the bottom of spoiler do not match the hole guides in the trunk. Is this a problem? I also did not like the fact that only machine screws, fastening up to the spoiler would be securing the spoiler. It seems that the best method would to have had bolts molded into the spoiler then using some lock washers and nuts to fasten the spoiler to the trunk.

Does anybody have any advise/experience with mounting a spoiler in the condition I received it as described above? I was thinking I could just drill per the holes where located on the spoiler, then using some kind of epoxy or cement to make sure the screws do not loosen from beneath the trunk.
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top